Anomalous diffusion of a particle in an aging medium

Noelle Pottier,Alain Mauger

DOI: https://doi.org/10.1016/j.physa.2003.10.034

2003-07-03

Abstract:We report new results about the anomalous diffusion of a particle in an aging medium. For each given age, the quasi-stationary particle velocity is governed by a generalized Langevin equation with a frequency-dependent friction coefficient proportional to $|\omega|^{\delta-1}$ at small frequencies, with $0<\delta<2$. The aging properties of the medium are encoded in a frequency dependent effective temperature $T_{\rm eff.}(\omega)$. The latter is modelized by a function proportional to $|\omega|^\alpha$ at small frequencies, with $\alpha<0$, thus allowing for the medium to have a density of slow modes proportionally larger than in a thermal bath. Using asymptotic Fourier analysis, we obtain the behaviour at large times of the velocity correlation function and of the mean square displacement. As a result, the anomalous diffusion exponent in the aging medium appears to be linked, not only to $\delta$ as it would be the case in a thermal bath, but also to the exponent $\alpha$ characterizing the density of slow modes.

Statistical Mechanics,Soft Condensed Matter

What problem does this paper attempt to address?

This paper mainly discusses the design and implementation of the trigger system in the ATLAS experiment. Specifically, the problem that the paper attempts to solve is how to effectively select physically interesting events and reduce the influence of background noise and known large - cross - section Standard Model physical processes under the conditions of high beam - crossing rate and interaction rate in the Large Hadron Collider (LHC). The solution of these problems is crucial for ensuring the efficiency and quality of the data acquisition system.

### Overview of the problems solved by the paper:

1. **Challenge of high data volume**:
- The beam - crossing rate of the LHC is 40 MHz, and there are approximately 25 proton - proton interactions in each beam - crossing. This results in a huge amount of data that cannot be all stored.
- Therefore, an efficient trigger system is required to screen out physically interesting events and reduce the data volume.

2. **Design of multi - level trigger system**:
- The ATLAS experiment adopts a multi - level trigger system, including hardware and software parts, to meet the above challenges.
- The system is divided into three levels:
- **Level - 1 trigger (LVL1)**: Based on hardware, it reduces the event rate from 40 MHz to below 75 kHz, and the decision - making time is completed within 2.5 microseconds.
- **Level - 2 trigger (LVL2)**: Based on optimized software algorithms, it further reduces the event rate to O(1) kHz.
- **Event filter (EF)**: It is also part of the high - level trigger system, using more complex algorithms for detailed event selection and classification, and finally reduces the event rate to about 200 Hz.

3. **Specific technical details**:
- **LVL1 trigger**: It mainly relies on the information of the ATLAS calorimeter and muon trigger chambers, and reduces the event rate through fast processing and decision - making.
- **LVL2 trigger**: It utilizes the information of all sub - detectors for more refined event selection.
- **Event filter**: It uses the complex algorithms of offline software for final event selection and classification.

### Conclusion:
The paper details the design principles, implementation methods, and performance evaluation of the trigger system in the ATLAS experiment, aiming to provide an efficient data screening mechanism to ensure that valuable physical events can be quickly and accurately identified in a high - data - volume environment. This is of great significance for scientific research on the LHC.