Abstract:Radio Frequency Interference (RFI) is emitted from various sources, terrestrial or orbital, and create a nuisance for ground-based 21cm experiments. In particular, single-dish 21cm intensity mapping experiments will be highly susceptible to contamination from these sources due to its wide primary beam and sensitivity. This work aims to simulate the contamination effects emitted from orbital sources in the Radio Navigational Satellite System within the 1100-1350 MHz frequency. This simulation can be split into two parts: (I) satellite positioning, emission power, and beam response on the telescope and (II) fitting of the satellite signal to data in order to improve the original model. We use previously observed single dish MeerKAT L-band data which needs to be specially calibrated to include data contaminated by satellite-based RFI. We find that due to non-linearity effects, it becomes non-trivial to fit the satellite power. However, when masking regions where this non-linearity is problematic, we can recreate the satellite contamination with high accuracy around its peak frequencies. The simulation can predict satellite movements and signal for past and future observations, which can help in RFI avoidance and testing novel cleaning methods. The predicted signal from simulations sits below the noise in the target cosmology window for the L-band (970 - 1015 MHz) making it difficult to confirm any out-of-band emission from satellites. However, a power spectrum analysis shows that such signal can still contaminate the 21cm power spectrum at these frequencies. In our simulations, this contamination overwhelms the auto-power spectrum but still allows for a clean detection of the signal in cross-correlations with mild foreground cleaning. Whether such contamination does exist one will require further characterization of the satellite signals far away from their peak frequencies.

RFI-Resistant Decimeter Band Radiometer for the RATAN-600 Radio Telescope

Development of a Dynamically Re-Configurable Radio-Frequency Interference Detection System for L-Band Microwave Radiometers

Radio Frequency Interference Detection and Mitigation Using Compressive Statistical Sensing

An Experimental setup to develop RFI mitigation techniques for radio astronomy

A FPGA-based Fast Converging Digital Adaptive Filter for Real-time RFI Mitigation on Ground Based Radio Telescopes

Radio Frequency Interference Mitigation at the WSRT

Satellite RFI mitigation on FAST

Spectral Kurtosis Based RFI Mitigation for CHIME

A survey of spatially and temporally resolved radio frequency interference in the FM band at the Murchison Radio-astronomy Observatory

Observational demonstration of a low-cost fast Fourier transform spectrometer with a delay-line-based ramp-compare ADC implemented on FPGA

Radio Frequency Interference from Radio Navigation Satellite Systems: simulations and comparison to MeerKAT single-dish data

A Broadband Digital Receiving System with Large Dynamic Range for Solar Radio Observation

The Radio Environment of the 21 Centimeter Array: RFI Detection and Mitigation

Real-time RFI filtering for uGMRT: Overview of the released system and relevance to the SKA

A Broadband Solar Radio Dynamic Spectrometer Working in the Millimeter-wave Band

Design and Implementation of Remote RFI Monitoring System for Ghana Radio Telescope Observatory-Nkutunse

The statistics of low frequency radio interference at the Murchison Radio-astronomy Observatory

Measurement Campaign of Radio Frequency Interference in a Portion of the C-Band (4–5.8 GHz) for the Sardinia Radio Telescope

The Brightness and Spatial Distributions of Terrestrial Radio Sources

Fourier domain excision of periodic radio frequency interference

IQRM: real-time adaptive RFI masking for radio transient and pulsar searches