Abstract:Acrylonitrile-butadiene rubbers (NBR) are widely used in the automotive industry, especially for lip seals of ball-bearings. Such an application requires specific materials properties either in terms of thermo-mechanical or tribological behaviours in the presence of lubricants. NBR filled with carbon black properly fulfils these conditions. Specifically, the lip seal contact area has to be large and the contact pressure high to prevent leakage. Weak contact friction enables the heat dissipation in this area to be decreased and improves the durability of ball bearings. Both requirements for the optimization of these materials lead us to investigate the relationship between the viscoelastic and tribological behaviours of NBR. The present study focuses on the characterization of two NBR using thermo-mechanical, viscoelastic and tribological experiments. The tribological set up consists of a 52100 steel sphere sliding over a sheet of the rubber specimen under dry conditions, which is the critical issue of such a contact. Two rubbers are investigated, mainly differing by their Tg values (ΔTg≈15°C). The tribological behaviour of the two materials is very different, while the difference in their mechanical properties is very limited. Rubber with a high Tg value seems to be protected against wear, unlike the rubber with the lowest Tg, on which long sliding induces a deep wear trace. Thermomechanical degradation occurs during the sliding and leads to surface modifications, which vary according to the nature of the rubber specimen. Experiments, results and comments address this difference of wear mechanism by relating it to the different characteristics of the sample surface: viscoelastic, thermo-mechanical and physicochemical (obtained by XPS analysis).

A method for the characterization of static elastomeric lip seal deformation

Experimental Characterization and Finite Element Modeling the Deformation Behavior of Rubbers with Geometry Defects

Experimental analysis and preliminary model of non-conventional lip seals

Finite Element Analysis of Reciprocating Sealing Component of Radial Single-piston Pump

A Mixed Lubrication Model for Lip Seals Based on Deterministic Surface Microdeformation

A Novel Technique for Mechanical Characterization of Thin Elastomeric Membrane

Prediction of the Contact Behavior of Stepseals: Experimental and Numerical Investigations

On the sealing mechanism of radial lip seals

The Non- Linear Contact Finite Element Analysis of Seal Structure on Large Scale Cutting Tube Machine

Analytical Model for Seal Contact Pressure

A Study of the Elastohydrodynamic Problem in Rectangular Elastomeric Seals

Nonlinear Finite Element Analysis of Inflatable Seals

Numerical Investigation of Elastomer Seal Performance

Determination of material parameters of rubber and composites for computational modeling based on experiment data

Influence of viscoelasticity on the tribological behaviour of carbon black filled nitrile rubber (NBR) for lip seal application

Mooney-Rivlin Parameter Determination Model as a Function of Temperature in Vulcanized Rubber Based on Molecular Dynamics Simulations

A Mixed Lubrication Theoretical Model and Experimental Verification of Rotary Lip Seals

Experimental and Numerical Investigation on Radial Impact of Pneumatic Tyre

Mixed Lubrication Modeling of Multi-Lip Reciprocating Seals Based on Elastohydrodynamic Lubrication Theory

Tangential contact modeling to seal considering elastic-plastic for lubrication transition mechanism

Nonlinear finite element analysis on the sealing performance of rubber packer for hydraulic fracturing