Abstract:Fully developed turbulent pipe flow at Re=11300 as well as Re=5300 is measured by PIV using water as working fluid. Excellent agreement with DNS (Direct Numerical Simulation) by Satake (2000) is achieved by choosing optimum measurement parameters such as spatial resolution, time separation of two images, and number of samples. The test section is 6.7m long stainless steel pipe with transparent PIV measurement section attached seamlessly at the end. The measurement section consists of transparent acrylic circular pipe of 1mm thick and water jacket with square cross section. The water jacket reduces the image distortion due to the pipe curvature in almost entire area of the pipe cross section to negligible level except for the region very close to the pipe wall. For turbulent flow measurement using PIV, the requirement for spatial resolution is very severe in order to resolve the fluctuating velocity field especially at high Reynolds number. Therefore, higher magnification is chosen at the cost of the size of measurement area to assure enough spatial resolution. Consequently, the size of the measurement area is half of the pipe radius and measurement is performed at two regions which are called near-wall region and pipe center. For image analysis, the iterative multi-step cross-correlation algorithm with spatio-temporal gradient method for subpixel refinement is used. Detail of the algorithm can be found in Scarano (1999) and Sugii (2000). The smallest interrogation window is 8x16 pixels which corresponds to 249 x 585μm. The near-wall structure is observed from vector map of fluctuating in-plane velocity components and out-of-plane component of vorticity fluctuation. The shear layer structure is clearly shown by vorticity fluctuation and ejection and sweep motion is also observed. The mean velocity profile and statistics are calculated from 4000 samples of vector map by first taking temporal statistics and then spatial average along streamwise direction and compared with DNS in non-dimensional form using friction velocity. Since accurate measurement of friction velocity is essential for the comparison with DNS, using pressure gradient is not appropriate due to the relatively small pressure drop along the pipe. Therefore, curve-fitting method using near-wall turbulent model developed by McEligot (1984) is applied to calculate friction velocity from the velocity profile in buffer region.

Experiments with Fluid Friction in Roughened Pipes

Deviation of Permeable Coarse‐grained Boundary Resistance from Nikuradse's Observations

A multi-state description of roughness effects in turbulent pipe flow

Roughness effects in laminar pipe flow

Critical Instability And Friction Scaling Of Fluid Flows Through Pipes With Rough Inner Surfaces

Measurements of turbulence statistics and near-wall structure of fully developed pipe flow at high Reynolds number

Comparison of Heat Transfer and Friction in Pipes With Various Internal Roughness

Prediction of Mean Turbulent Flow Velocity in a Permeable-Walled Pipe

Turbulent flow of Newtonian and non-Newtonian fluids in rough channels: Part I: Roughness effect on Newtonian fluids

Numerical Investigation On The Effect Of Roughness On The Flow Resistance For Incompressible Fluid Flow In Microtubes

Effects of Structured Roughness on Fluid Flow at the Microscale Level

Unified Friction Formulation from Laminar to Fully Rough Turbulent Flow

Direct Numerical Simulation and Theory of a Wall-Bounded Flow with Zero Skin Friction

Friction factor decomposition for rough-wall flows: theoretical background and application to open-channel flows

Skin-Friction and Forced Convection from Rough and Smooth Plates

Experimental study of a turbulent boundary layer with a rough-to-smooth change in surface conditions at high Reynolds numbers

Direct numerical simulation of open-channel flow over a fully-rough wall at moderate relative submergence

The hydraulic resistance paradox in rapid narrow pipe waterflow

A New Low-Reynolds-Number k-ε Model for Turbulent Flow Over Smooth and Rough Surfaces

Prandtl number effects on passive scalars in turbulent pipe flow

Effects of Roughness on Fluid Flow Behavior in Ducts