Abstract:Transition edge sensor (TES) detectors are showing great promise as single photon detectors in quantum information [1] and as fast bolometers in astronomical applications [2]. In the near infrared/optical range TESs offer good broadband quantum efficiency, high time resolution, and modest energy resolution. Therefore TESs provide the potential capabilities for the study of rapidly varying compact object systems. We are developing Ti-based TES as optical/near-infrared photon detectors [3]. The TES sensors are photolithographically patterned ~50 nm thick Ti films deposited on quartz substrate. These films exhibit a sharp superconducting to normal transition at about 400 mK. Niobium films are used as superconducting leads for the devices. The sensors were mounted on the mixture stage of a Triton 400 dilution refrigerator. The sensor temperature is maintained within its superconducting to normal transition via the Joule heating produced by the voltage bias due to strong negative electrothermal feedback. A series array of dc SQUIDs, working as current-sensitive amplifiers readout the signal. The photons were introduced through a single-mode fiber with a 9 μm core and a 125 μm cladding. The fiber is aligned to the active area of the TES with the help of IR microscope to provide high coupling efficiency. We have measured the current-voltage curves at different bath temperatures, based on which the calculated thermal conductance is ~300 pW/K for the 10μm×20μm TES (2C1) fabricated on a 1550 nm dielectric mirror. The effective time constant is about 20 μs. The input power is measured by a power meter and then attenuated by 42-45 dB. The absorbed power is the integral of the corresponding drop in current multiplied by the bias voltage. Thus system efficiency is the ratio of absorbed power to the input power. Fig. 1 shows the measured system efficiency as a function of their normalized resistance. The highest system efficiency is 33 %

UV-IR Science Prospects with TES Imaging Arrays

First Astronomical Application of a Cryogenic TES Spectrophotometer

Transition-Edge Sensors for cryogenic X-ray imaging spectrometers

Design of Large Low Noise Transition Edge Sensor Arrays for Future FIR Space Missions

Beamline Spectroscopy of Integrated Circuits With Hard X-ray Transition Edge Sensors at the Advanced Photon Source

Big Science with a nUV-MidIR Rapid-Response 1.3m telescope at L2

Development of sensitive long-wave infrared detector arrays for passively cooled space missions

Mid-infrared detector development for the Origins Space Telescope

Design and Development of a 224-pixel TES X-Ray Microcalorimeter System for Microanalysis with STEM

Energy calibration of high-resolution X-Ray TES microcalorimeters with 3 eV optical photons

High-Resolution Gamma-Ray Spectroscopy with A Microwave-Multiplexed Transition-Edge Sensor Array

Hard X-ray Fluorescence measurements with TESs at the Advanced Photon Source

Calibration and Testing of Small High-Resolution Transition Edge Sensor Microcalorimeters with Optical Photons

Microchannel-Plate Detector Development for Ultraviolet Missions

Transition edge sensor (TES) detectors are showing great promise as single photon detectors in quantum information

Characterization of high aspect ratio TiAu TES X-ray microcalorimeters array using the X-IFU Frequency Domain Multiplexing readout

The Infrared Imaging Spectrograph (iris) for Tmt: Latest Science Cases and Simulations

Emu: A Case Study for TDI-like Imaging for Infrared Observation from Space

Development of the cadmium zinc TElluride Radiation Imager (TERI)

Frequency domain multiplexing readout for large arrays of transition-edge sensors

Evaluating the GeoSnap 13-$μ$m Cut-Off HgCdTe Detector for mid-IR ground-based astronomy