Resolving Two Beams in Beam Splitters with a Beam Position Monitor

Sergey Kurennoy

DOI: https://doi.org/10.48550/arXiv.physics/0205066

2002-05-24

Abstract:The beam transport system for the Advanced Hydrotest Facility (AHF) anticipates multiple beam splitters [1]. Monitoring two separated beams in a common beam pipe in the splitter sections imposes certain requirements on diagnostics for these sections. In this note we explore a two-beam system in a generic beam monitor and study the feasibility of resolving the positions of the two beams with a single diagnostic device.

Accelerator Physics

What problem does this paper attempt to address?

The problem that this paper attempts to solve is to use a single diagnostic device (such as a beam position monitor, BPM) in a beam splitter to distinguish the positions of two separated proton beams. Specifically, the research aims to explore how to determine the lateral positions (including the central position and the spacing) of two proton beams by measuring the induced currents at four specific points, especially when they are widely separated in the horizontal plane.

### Problem Background

In the beam transport system of the Advanced Hydrotest Facility (AHF), it is necessary to extract 20 - nanosecond proton beam pulses from the 50 - GeV main proton synchrotron and transport them to the target through a complex transport system. The beam splitter in the transport system splits the beam into multiple parts so that multi - axis proton radiography can be carried out simultaneously. In order to ensure that these split beams can be accurately measured at the correct positions, there must be a method to monitor the positions of multiple beams in the same pipe simultaneously.

### Main Challenges

1. **Beam Separation**: In the beam splitter, the two beams have a large separation in the horizontal direction.
2. **Beam Position Monitoring**: A method is needed to accurately measure the lateral positions (including their central positions and relative distances) of these two beams.
3. **Beam Intensity Difference**: The intensities of the two beams may not be equal, which increases the complexity of monitoring.

### Solution

The paper proposes a method based on the beam position monitor (BPM). By measuring the induced currents at four specific points (R, T, L, B), these signals are used to derive the lateral position information of the two beams. The specific steps are as follows:

1. **Establish a Mathematical Model**: Through theoretical derivation, the lateral electric fields generated by the two beams on the wall of the cylindrical vacuum chamber are calculated and simplified into a two - dimensional electrostatic problem.
2. **Introduce Parametric Descriptions**: Two new vectors are defined to describe the positional relationship between the two beams, namely the central position of the charge distribution of the two beams \( \mathbf{a} \) and the beam spacing \( \mathbf{d} \).
3. **Signal Ratio Analysis**: By analyzing the ratios of the induced current signals at different positions, especially \( (R + L - T - B)/S \) and \( (T - B)/S \), the central position and spacing information of the beams can be extracted.
4. **Consider Beam Asymmetry and Intensity Difference**: Correction terms for beam asymmetry and intensity difference are introduced to improve the measurement accuracy.

### Conclusion

Through the above method, the paper proves that under certain conditions, a single four - wire beam position monitor can reliably distinguish the lateral positions of two separated proton beams, even if their intensities are different. This is very important for multi - axis proton radiography in the AHF beam transport system.