Abstract:The MAX phase has attracted much attention due to its unique properties combined with the merits of both metal and ceramic, including the low density, high electrical conductivity and good oxidation resistance, which makes it significant for possible applications in various high temperature or other environments. There is a lot of research work on Ti2AlX (X=C, N). However little research about thermodynamic properties at high pressure is carried out. So we study the structural, mechanical and thermodynamic properties of Ti2AlC and Ti2AlN at various pressures and temperatures. The first-principles calculations based on electronic density-functional theory framework are used to investigate the properties at various pressures. The cut-off energy is 350 eV. Converged results are achieved with 10102 special K-point meshes. The self-consistent convergence of total energy is set to be 5.010-6 eV/atom. According to the calculated structural parameters at various pressures, we can find that the ratios V/V0 (V0 denotes the system volume at 0 GPa) of Ti2AlX are reduced by 20.59% and 18.93%, respectively, so the compressibility of the system is strong. As the internal pressure increases, the curves of V/V0 become gentle. Then we calculate elastic constants at pressures ranging from 0 to 50 GPa in steps of 10 GPa. It is obvious that the Ti2AlX is mechanically stable because all of the elastic constants satisfy the Born stability criteria. The bulk modulus, shear modulus and Young's modulus linearly increase with internal pressure increasing, implying that the pressure can improve the resistance to volume deformation. The ductility and brittleness can be judged according to Pugh's criterion (ratio of bulk modulus to shear modulus B/G), and the brittle nature turns into ductile nature in a pressure range of 40-50 GPa for the Ti2AlX since the value of B/G exceeds 1.75. Finally, we study the thermodynamic properties at various pressures and temperatures based on the quasi-harmonic Debye approximation theory, including the bulk modulus, heat capacity and thermal expansion coefficient. The bulk modulus decreases with temperature increasing but increases with pressure increasing. The heat capacity at constant volume Cv and the heat capacity at constant pressure Cp have the same variation tendency, while Cv obeys the Dulong-Petit limit. It is easy to see that temperature and pressure have opposite influences on heat capacity and the effect of temperature is more significant than that of pressure. The effects of temperature and pressure on linear expansion coefficient mainly occur at low temperature and the effect of pressure is not so considerable when the pressure exceeds 30 GPa. Above all, the effects of temperature and pressure on thermodynamic properties are inverse.

Experimental determination of thermal expansivity of calcium ferrite-type MgAl2O4 and its application to thermodynamical assessment of thermoelastic parameters

High-pressure Raman spectroscopy, vibrational mode calculation, and heat capacity calculation of calcium ferrite-type MgAl2O4 and CaAl2O4

Thermodynamic properties of calcium ferrite-type MgAl 2 O 4 : A first principles study

A High P-T Single-Crystal X-ray Diffraction Study of Thermoelasticity of MgSiO 3 Orthoenstatite

A high P-T single-crystal X-ray diffraction study of thermoelasticity of MgSiO<sub>3</sub> orthoenstatite

In-situ High-Temperature XRD and FTIR for Calcite, Dolomite and Magnesite: Anharmonic Contribution to the Thermodynamic Properties

Thermoelastic properties of (Mg0.64Fe0.36)O ferropericlase based on in situ X-ray diffraction to 26.7 GPa and 2173 K

Thermal Equations of State for Titanium Obtained by High Pressure—temperature Diffraction Studies

Structural, Mechanical, and Thermodynamic Properties of Ti2AlX (X = C, N) at High Pressure

Thermal Performance Determination of Binary Fe-Al Alloys at Elevated Temperatures

In Situ High P‐T X Ray Diffraction Studies on Three Polymorphs (α, Β, Γ) of Mg2SiO4

Thermoelastic equation of state of jadeite NaAlSi2O6: An energy-dispersive Reitveld Refinement Study of low symmetry and multiple phases diffraction

Thermoelastic and Texture Behavior of Aluminum at High Pressure and High Temperature Investigated by in Situ Neutron Diffraction

Specific Heat and Thermal Expansion of Refractory Nonmetal: CaO

First‐principles Study of High‐pressure Elasticity of CF‐ and CT‐structure MgAl2O4

Thermal expansivity in the lower mantle

Thermal expansion of magnesium aluminum oxynitride (Mg0.1Al 1.6O2.2N0.2)

Second-order bulk modulus with thermal expansivity for nanomaterials

Pressure Effects on the Thermodynamic Properties of MgSiO3 Akimotoite

Thermoelastic equation of state and melting of Mg metal at high pressure and high temperature

Investigation of the thermal expansion of the refractory materials at high temperatures