Abstract:The hybrid electrode of single-wall carbon nanotubes (SWCNTs)/Cu2O/ZnO nanorods (NRs)/graphene used on the current-response nonenzymatic glucose sensor was investigated herein, regarding the mechanism of the formation of functional channel. The synthesis of the hybrid electrode involved four steps. First, the graphene was grown by chemical vapor deposition (CVD) and then wet-transferred onto indium transparent oxide (ITO) glass. Second, a zinc oxide (ZnO) seed layer was sputtered onto the graphene/ITO glass, and ZnO NRs were gradually grown by the hydrothermal method. Third, the ZnO NRs were clad with cuprous oxide (Cu2O) by the electrochemical method. Fourth, the SWCNTs were dropped onto the Cu2O surface, with a Nafion surfactant. X-ray diffraction spectra, scanning electron microscopy spectra, Raman spectra, cyclic voltammograms, and amperometric response diagrams were used to verify the performance of the device. Results showed that sensitivity increased significantly from 11.2 to 289.8 μA mM–1 cm–2, linear range increased significantly from 0.6 to 11.1 mM, and the coefficient of determination (R2) increased from 0.9766 to 0.9923, all by the addition of the SWCNTs/Cu2O functional channel mechanism and without graphene. When the graphene was added to the functional channel electrode, sensitivity increased again from 289.8 to 466.1 μA mM–1 cm–2 at low concentrations.The Supporting Information is available free of charge at <a class="ext-link" href="/doi/10.1021/acsami.0c07943?goto=supporting-info">https://pubs.acs.org/doi/10.1021/acsami.0c07943</a>.Deposition parameters of the ZnO seed layer, deposition parameters of the chronoamperometry method, fabrication process of wet transfer of graphene onto ITO glass, ZnO NRs grown with the hydrothermal method, fabrication process of Cu2O on the ZnO NRs by the electroplated method, and fabrication process of SWCNTs onto Cu2O/ZnO NRs (<a class="ext-link" href="/doi/suppl/10.1021/acsami.0c07943/suppl_file/am0c07943_si_001.pdf">PDF</a>)This article has not yet been cited by other publications.

Synthesis of Au or Ag/Cu2O/ aluminum doped zinc oxide nanorods hybrid electrode for high sensitive non-enzymatic glucose sensor: Mechanism investigation of formation and surface plasmon resonance

Cu-Doped ZnO Nanoparticles for Non-Enzymatic Glucose Sensing

A Highly Sensitive Nonenzymatic Glucose Sensor Based on Cu/Cu2O Composite Nanoparticles Decorated Single Carbon Fiber

ZnO Nanorods/au Hybrid Nanocomposites for Glucose Biosensor.

Functional Channel of SWCNTs/Cu 2 O/ZnO NRs/Graphene Hybrid Electrodes for Highly Sensitive Nonenzymatic Glucose Sensors

A Sensitive and Selective Non-Enzymatic Glucose Sensor Based on AuNPs/CuO NWs-MoS2 Modified Electrode

Highly Sensitive And Portable Electrochemical Detection System Based On Aunps@Cuo Nws/Cu2o/Cf Hierarchical Nanostructures For Enzymeless Glucose Sensing

Sensitive electrochemical nonenzymatic glucose sensing based on anodized CuO nanowires on three-dimensional porous copper foam

Improved Non-enzymatic Glucose Sensors of ZnO Nanorods by Adsorb Pt Nanoparticles

CuO-Ag2O nanoparticles grown on a AgCuZn alloy substrate in situ for use as a highly sensitive non-enzymatic glucose sensor

Nanoporous CuZn supported CuO nanoparticle electrodes for non-enzymatic electrochemical glucose detection

A novel high-sensitivity non-enzymatic glucose sensor via Cu2O@CuO@NiCo2O4 nanowires as catalyst

A Non-Enzymatic Glucose Sensor Based on Copper Oxide Nanowires-Singlewall Carbon Nanotubes

Highly Efficient Non-Enzymatic Glucose Sensor Based on CuO Modified Vertically-Grown ZnO Nanorods on Electrode.

Synthesis of Copper Nanorods for Non-Enzymatic Amperometric Sensing of Glucose

Facile Non-Enzymatic Electrochemical Sensing for Glucose Based on Cu2O–BSA Nanoparticles Modified GCE

A High Sensitive Glucose Sensor Based on Ag Nanodendrites/cu Mesh Substrate Via Surface-Enhanced Raman Spectroscopy and Electrochemical Analysis

An Integrated Anode Based on Porous Ni/Cu(OH)2 Nanospheres for Non-Enzymatic Glucose Sensing

Exploiting Synergistic Interaction in Cu-Zn-Ni Alloy Oxide Films Prepared by One-Step Anodizing for a Highly Sensitive Non-Enzymatic Glucose Sensor

Facile synthesis of nanospindle-like Cu2O/straight multi-walled carbon nanotube hybrid nanostructures and their application in enzyme-free glucose sensing

Nano nickel oxide modified non-enzymatic glucose sensors with enhanced sensitivity through an electrochemical process strategy at high potential