Mg anode interface engineering in KNO 3 electrolyte with sodium 5-sulfosalicylate as an additive for enhanced performance of Mg-air batteries

Guanhua Lin,Yaqing Zhou,Sandrine Zanna,Antoine Seyeux,Philippe Marcus,Jolanta Światowska
DOI: https://doi.org/10.1016/j.jma.2024.09.007
IF: 11.813
2024-10-12
Journal of Magnesium and Alloys
Abstract:Highlights • Enhanced performance of Mg-air batteries in KNO3-based electrolytes with the addition of 5SS. • Inhibition of Mg corrosion and hydrogen evolution reaction in KNO3-based electrolytes. • Improved discharge potential at various applied current densities with the addition of 5SS into KNO3-based electrolytes. • Formation of a thinner and ionically conductive surface layer with the addition of 5SS. The Mg-air batteries face limitations with pronounced hydrogen evolution and low anodic utilization efficiency from Mg anodes in conventional NaCl electrolytes. The corrosion performance, surface composition, and discharge properties of commercial purity Mg anodes were thoroughly investigated in KNO 3 electrolytes with and without sodium 5-sulfosalicylate and compared to NaCl electrolyte. The addition of sodium 5-sulfosalicylate to KNO 3 -based electrolyte results in efficient inhibition of H 2 evolution, consequently enhancing anodic utilization efficiency to 84 % and specific capacity to 1844 mAh/g, compared to NaCl (24 % and 534 mAh/g, respectively) under discharge condition of 10 mA/cm 2 in half cell. Furthermore, the chelating ability of sodium 5-sulfosalicylate can significantly improve the Mg surface dissolution kinetics and discharge product deposition rate at the Mg anode / electrolyte interface, yielding formation of a thinner discharge layer as confirmed by time-of-flight secondary ion mass spectrometry. The discharge voltage is increased to 1.60 V, compared to 1.35 V in KNO 3 at 0.5 mA/cm 2 in full cell. However, higher concentration of sodium 5-sulfosalicylate can accelerate Mg anode dissolution, impeding the improvement of anodic utilization efficiency, specific capacity, and energy density. Hence, determining optimal additive concentration and current density is crucial for enhancing the discharge properties of Mg-air batteries and mitigating excessive Mg dissolution in chloride-free electrolytes. Graphical abstract Download: Download high-res image (247KB) Download: Download full-size image
metallurgy & metallurgical engineering
What problem does this paper attempt to address?