Abstract:The response to the COVID-19 epidemic is generating severe shortages of personal protective equipment around the world. In particular, the supply of N95 respirator masks has become severely depleted, with supplies having to be rationed and health care workers having to use masks for prolonged periods in many countries. We sought to test the ability of 7 different decontamination methods: autoclave treatment, ethylene oxide gassing (ETO), low temperature hydrogen peroxide gas plasma (LT-HPGP) treatment, vaporous hydrogen peroxide (VHP) exposure, peracetic acid dry fogging (PAF), ultraviolet C irradiation (UVCI) and moist heat (MH) treatment to decontaminate a variety of different N95 masks following experimental contamination with SARS-CoV-2 or vesicular stomatitis virus as a surrogate. In addition, we sought to determine whether masks would tolerate repeated cycles of decontamination while maintaining structural and functional integrity. All methods except for UVCI were effective in total elimination of viable virus from treated masks. We found that all respirator masks tolerated at least one cycle of all treatment modalities without structural or functional deterioration as assessed by fit testing; filtration efficiency testing results were mostly similar except that a single cycle of LT-HPGP was associated with failures in 3 of 6 masks assessed. VHP, PAF, UVCI, and MH were associated with preserved mask integrity to a minimum of 10 cycles by both fit and filtration testing. A similar result was shown with ethylene oxide gassing to the maximum 3 cycles tested. Pleated, layered non-woven fabric N95 masks retained integrity in fit testing for at least 10 cycles of autoclaving but the molded N95 masks failed after 1 cycle; filtration testing however was intact to 5 cycles for all masks. The successful application of autoclaving for layered, pleated masks may be of particular use to institutions globally due to the virtually universal accessibility of autoclaves in health care settings. Given the ability to modify widely available heating cabinets on hospital wards in well-resourced settings, the application of moist heat may allow local processing of N95 masks.

Investigation of three different UV-C irradiation schemes for bacterial decontamination of FFP2 masks to make them reusable

Ultraviolet germicidal irradiation of influenza-contaminated N95 filtering facepiece respirators

Disinfection of Respirators with Ultraviolet Radiation

Exploring Reusability of Disposable Face Masks: Effects of Disinfection Methods on Filtration Efficiency, Breathability, and Fluid Resistance

Feasibility study of reusing surgical masks and evaluation of the effectiveness of different disinfection methods

Feasibility of Reusing Surgical Mask Under Different Disinfection Treatments

Successful establishment and evaluation of a reprocessing concept via steam at 105 °C for FFP masks in hospitals in case of logistic shortages

Effectiveness of Ultraviolet-C Light and a High-Level Disinfection Cabinet for Decontamination of N95 Respirators

Design and Analysis of a Novel Ultraviolet-C Device for Surgical Face Mask Disinfection

Decontamination of N95 masks for re-use employing 7 widely available sterilization methods

Decontamination of a surgical mask with UV-C irradiation: analysis of experimental results with optical simulations

Fast and Deep Disinfection for Face Masks Recycle Using Vacuum Ultraviolet Irradiation

Effects of Ultraviolet Germicidal Irradiation (UVGI) on N95 Respirator Filtration Performance and Structural Integrity

UV-C decontamination for N95 emergency reuse: Quantitative dose validation with photochromic indicators

N95 respirator reuse, decontamination methods, and microbial burden: A randomized controlled trial

Strategies for the reuse of N95 and N99 respiratory masks during the COVID-19 pandemic

Comparison of Two Methods for Sterilization of Filtering Facepiece Respirators Worn for Extended Periods During the COVID-19 Pandemic: An Experimental Laboratory Study

Cold Atmospheric Plasma Sterilization of FFP3 Face Masks and Long-Term Material Effects

The Use of UVC Irradiation to Sterilize Filtering Facepiece Masks Limiting Airborne Cross-Infection

Setup of a method supporting the adoption of a regeneration strategy for FFP2 masks used by rescuers during the Covid-19 emergency

Healthcare worker mask reuse in a global pandemic: Using idle resources to create an inexpensive, scalable, and accessible UV system for N95 sterilization