Abstract:The response to the COVID-19 epidemic is generating severe shortages of personal protective equipment around the world. In particular, the supply of N95 respirator masks has become severely depleted, with supplies having to be rationed and health care workers having to use masks for prolonged periods in many countries. We sought to test the ability of 7 different decontamination methods: autoclave treatment, ethylene oxide gassing (ETO), low temperature hydrogen peroxide gas plasma (LT-HPGP) treatment, vaporous hydrogen peroxide (VHP) exposure, peracetic acid dry fogging (PAF), ultraviolet C irradiation (UVCI) and moist heat (MH) treatment to decontaminate a variety of different N95 masks following experimental contamination with SARS-CoV-2 or vesicular stomatitis virus as a surrogate. In addition, we sought to determine whether masks would tolerate repeated cycles of decontamination while maintaining structural and functional integrity. All methods except for UVCI were effective in total elimination of viable virus from treated masks. We found that all respirator masks tolerated at least one cycle of all treatment modalities without structural or functional deterioration as assessed by fit testing; filtration efficiency testing results were mostly similar except that a single cycle of LT-HPGP was associated with failures in 3 of 6 masks assessed. VHP, PAF, UVCI, and MH were associated with preserved mask integrity to a minimum of 10 cycles by both fit and filtration testing. A similar result was shown with ethylene oxide gassing to the maximum 3 cycles tested. Pleated, layered non-woven fabric N95 masks retained integrity in fit testing for at least 10 cycles of autoclaving but the molded N95 masks failed after 1 cycle; filtration testing however was intact to 5 cycles for all masks. The successful application of autoclaving for layered, pleated masks may be of particular use to institutions globally due to the virtually universal accessibility of autoclaves in health care settings. Given the ability to modify widely available heating cabinets on hospital wards in well-resourced settings, the application of moist heat may allow local processing of N95 masks.

Strategies for the reuse of N95 and N99 respiratory masks during the COVID-19 pandemic

Development of a rapid plasma decontamination system for decontamination and reuse of filtering facepiece respirators

Decontamination of N95 masks for re-use employing 7 widely available sterilization methods

Exploring Reusability of Disposable Face Masks: Effects of Disinfection Methods on Filtration Efficiency, Breathability, and Fluid Resistance

Extended Use or Reuse of Single-Use Surgical Masks and Filtering Face-Piece Respirators During the Coronavirus Disease 2019 (COVID-19) Pandemic: A Rapid Systematic Review

Developing home-disinfection and filtration efficiency improvement methods for N95 respirators and surgical facial masks: stretching supplies and better protection during the ongoing COVID-19 Pandemic

Filtration Efficiency of N95 Filtering Facepiece Respirators During Multi-Cycles of ‘8-Hour Simulated Donning + Disinfection’

Experimental study on disinfection and reuse of disposable masks

Can Masks Be Reused After Hot Water Decontamination During the COVID-19 Pandemic?

Fiber-Based Masks and Respirators: Using Decontamination Methods and Antimicrobial Treatment to Improve Its Reusability during Pandemic

Thinking green: modelling respirator reuse strategies to reduce cost and waste

Setup of a method supporting the adoption of a regeneration strategy for FFP2 masks used by rescuers during the Covid-19 emergency

Feasibility of Reusing Surgical Mask Under Different Disinfection Treatments

Efficacy and safety of decontamination for N95 respirator reuse: a systematic literature search and narrative synthesis

Fabrication of a High-Performance and Reusable Planar Face Mask in Response to the COVID-19 Pandemic

Feasibility study of reusing surgical masks and evaluation of the effectiveness of different disinfection methods

Can sterilization of disposable face masks be an alternative for imported face masks? A nationwide field study including 19 sterilization departments and 471 imported brand types during COVID-19 shortages

Autoclave sterilization and ethanol treatment of re-used surgical masks and N95 respirators during COVID-19: impact on their performance and integrity

Decontamination of disposable respirators for reuse in a pandemic employing in-situ-generated peracetic acid

Dry heat sterilization as a method to recycle N95 respirator masks: The importance of fit

Gravity steam reprocessing in healthcare facilities for the reuse of N95 respirators