Abstract:Numerous studies have demonstrated that under low-velocity, low-energy impact conditions, although the surface damage to fiber-reinforced composite laminates may be minimal, significant internal damage can occur. Consequently, a progressive damage finite element model was specifically developed for thermoplastic carbon fiber-reinforced composite laminates subjected to low-speed impact loads, with the objective of analyzing the damage behavior of laminates under impacts of varying energy levels. The model utilizes a three-dimensional Hashin criterion for predicting intralayer damage initiation, with cohesive elements based on bilinear traction-separation law for predicting interlaminar delamination initiation, and incorporates a damage constitutive model based on equivalent displacement to characterize fiber damage evolution, along with the B-K criterion for interlaminar damage evolution. The impact response of laminates at energy levels of 5 J, 10 J, 15 J, 20 J, and 25 J was analyzed through numerical simulation, drop-hammer experiments, and XCT non-destructive testing. The results indicated that the simulation outcomes closely correspond with the experimental findings, with both the predicted peak error and absorbed energy error maintained within a 5% margin, and the trends of the mechanical response curves aligning closely with the experimental data. The damage patterns predicted by the numerical simulations were consistent with the results obtained from XCT scans. The study additionally revealed that the impact damage of the laminates primarily stems from interlaminar delamination and intralayer tensile failure. Initial damage typically presents as internal delamination; hence, enhancing interlaminar bonding performance can significantly augment the overall load-bearing capacity of the laminate.

Manipulating impact damage modes in composite laminates by helical pitch angle and ply thickness

Cross-helicoidal Approach to the Design of Damage-Resistant Composites

Increasing the Compressive Strength of Helicoidal Laminates after Low-Velocity Impact upon Mixing with 0° Orientation Plies and Its Analysis

Experimental Investigation of Z-pin Insertion Angles on the Mechanical Behavior and Failure Mechanism of Compression after Impact for CFRP Laminates

Effect of Z-pin Insertion Angles on Low-Velocity Impact Mechanical Response and Damage Mechanism of CFRP Laminates with Different Layups

Influence of Various Damage Mechanisms on the Low‐velocity Impact Response of Composite Laminates

Low‐velocity impact damage and compression after impact behavior of CF/PEEK thermoplastic composite laminates

Damage and residual compressive strength of multi-layer composite laminates after low velocity impact

Influence of Fiber Cutting at the Composite Grid Intersection on the Compressive Performance of Laminate

Gradient ply thickness design for enhanced low-velocity impact resistance in ultra-thin ply composite

Three notable design strategies for manipulating failure modes in open-hole tensile composite laminates

Thin/thick-ply hybrid gradient laminate for low-velocity impact and compression-after-impact behaviors

Finite element analysis on impact response and damage mechanism of composite laminates under single and repeated low-velocity impact

Predicting Damage Behaviors of Composite Laminates under Multiple Low‐velocity Impacts

Experimental and Simulation Study on Failure of Thermoplastic Carbon Fiber Composite Laminates under Low-Velocity Impact

Behaviors of Composite Laminates under Low-Energy Impact Using a Novel Analytical Framework

Insights into the high-velocity impact behaviour of bio-inspired composite laminates with helicoidal lay-ups

Impact damage in composite aircraft structures-experimental testing and numerical simulation

Optimizing Damage Resistance of Composite under Low-Velocity Impact Based on the Application of Solid-Shell Coupling Model

Low‐velocity impact behavior of composite laminates based on bio‐inspired stacking sequence

On multiple low-velocity impact response and compression after impact of composite laminates