Abstract:Mineral fillers are an essential component of asphalt concrete. Significant amounts of mineral fillers are used in constructing asphalt pavement. However, mineral fillers are an important non-renewable natural resource which needs to be preserved. In addition, the production of mineral fillers also consumes much energy and affects environment negatively. This study set out to explore the feasibility of upcycling waste phosphogypsum as an alternative filler for asphalt concrete. The phosphogypsum was first pretreated at 60, 160, and 800 °C, and the crystalline phase of phosphogypsum was evaluated by X-ray diffraction (XRD). Phosphogypsum with three crystalline phases and limestone powder were then mixed with base asphalt binders to prepare asphalt mastic at the filler-asphalt ratio of 1:1 at 150 °C. The chemical structural changes and thermal stability features of phosphogypsum asphalt mastic were analyzed using Fourier transform infrared spectroscopy (FTIR) and thermogravimetry (TG). The viscoelasticity, high-temperature performance, and fatigue characteristics of different asphalt mastics were measured by frequency sweep, multiple stress creep and recovery (MSCR), and linear amplitude sweep (LAS), respectively. The results indicate that phosphogypsum had different crystalline phases after pretreatment at different temperatures. The addition of phosphogypsum as fillers in asphalt is mainly a physical hardening effect. The 600 °C residual mass ratio of asphalt mastic prepared from phosphogypsum pretreated at 60, 160, and 800 °C was 53.9%, 56.2%, and 58.6%. As the temperature increased, the different crystallized water states in phosphogypsum were decomposed. The replacement of mineral powder with phosphogypsum can improve the high-temperature properties of asphalt mastic and the percent recovery ( R ), while the nonrecoverable creep compliance ( J nr ) was reduced. At the extremely high-temperature of 70 °C, the improvement of the high-temperature performance of phosphogypsum asphalt mastic is more evident than that of 46 °C. Furthermore, the addition of phosphogypsum also reduced the fatigue life of asphalt mastic. This study is expected to paving the road for the upcycling of waste phosphogypsum as an alternative filler in asphalt pavement.

Multi-scale investigation of the adhesion properties of phosphogypsum whisker composite modified asphalt

Microscopic Analysis of Aging Effects on the Adhesion Properties Between Asphalt and Mineral Aggregate

Enhancement of Rheological Performance and Compatibility of Tire Rubber-Modified Asphalt Binder with the Addition of Graphene

Use of Multi-Scale Investigation to Evaluate Adhesion Performance of Warm-Mix Polymer-Modified Asphalt

Multi-scale Investigation on Water Stability and Anti-Aging Performance of Granite Asphalt Mixture Modified with Composite Anti-Stripping Agents

The short-term aging effect on the interface and surface wetting behavior of modified asphalt mixtures

Interfacial Water Stability between Modified Phosphogypsum Asphalt Mortar and Aggregate Based on Molecular Dynamics

Study on Adhesion Performance and Aging Strength Degradation Mechanism of SBS Modified Asphalt with Different Anti-Aging Additive

Multi scale investigation on the failure mechanism of adhesion between asphalt and aggregate caused by aging

Adhesion Characteristics of Graphene-Modified Asphalt Using Surface-Free Energy Method

Aging resistance of polyurethane/graphene oxide composite modified asphalt: performance evaluation and molecular dynamics simulation

Study on the anti-aging properties of organic attapulgite (OATT) and polyurethane (PU) composite-modified asphalt

Upcycling waste phosphogypsum as an alternative filler for asphalt pavement

Research on the Fatigue Performance of Asphalt Mixtures Using Phosphogypsum Whisker as Substitute Filler

Development of Interfacial Adhesive Property by Novel Anti-Stripping Composite between Acidic Aggregate and Asphalt

Properties of polymer modified asphalt by polyphosphoric acid through molecular dynamics simulation and experimental analysis

The Effects of Aging on Microstructures and Rheological Properties of Modified Asphalt with GO/SBS Composite

Relation Between Adhesion Properties and Microscopic Characterization of Polyphosphoric Acid Composite SBS Modified Asphalt Binder

Effect of Graphene Oxide on Aging Properties of Polyurethane-SBS Modified Asphalt and Asphalt Mixture

The Effect of Aging on the Molecular Distribution of Crumb Rubber Modified Asphalt Based on the Gel Permeation Chromatography Test

Effect of Phosphogypsum Based Filler on the Performance of Asphalt Mortar and Mixture