Abstract:This paper addresses the acoustic and aerodynamic characteristics of small rotor configurations, including the influence of the rotor–rotor interactions. For this purpose, a Rotor/Rotor/Pylon configuration is chosen for both the test and numerical simulations. The wind tunnel experiments on various rotor configuration were performed in DLR's Acoustic Wind Tunnel Braunschweig (AWB). The experiments involve isolated rotors, and rotors in tandem and coaxial configuration in hover and forward flight. For numerical simulations, an unsteady free wake 3D panel method (UPM) is used to account for aerodynamic non-linear effects associated with the mutual interference among the Rotor/Rotor/Pylon configurations. The effect of the pylon is simulated using potential theory in form of a panelized body. Finally, the sound propagation into the far field is calculated with DLR's FW–H code APSIM, using UPM blade surface pressure as input. The validation effort is supported by CFD TAU steady simulations on selected hover test cases. The experiments and numerical results indicate that the noise at the blade passing frequency (BPF) and its higher harmonics is the dominant source of the noise for the present rotor selection. The extra subharmonics between two BPFs appearing in the results are caused by the small geometric discrepancy between the blades as well as the motor noise. Broadband noise is also observed in the experiment, but its contribution to the overall sound pressure is very small and can be neglected. The simulation of the acoustic scattering from the rotor support system for the isolated rotor cases indicated an influence about 1–3 dB on the overall sound pressure of the polar microphones. In both the coaxial and the tandem configuration, the acoustic interferences are particularly well visible in the numerical simulations and cause a more complex noise directivity. There is almost no change in time-averaged inflow by applying phase angles. In the coaxial condition, in hover, the phase delay between rotors does not change the maximum noise level. In forward flight, the phase delay can influence the maximum level of the noise radiation. In both coaxial and tandem configuration, the position of the downstream rotor is key for the noise radiation, and therefore, avoiding the interaction with upstream wake can reduce the noise radiation.

Experimental investigation on the aeroacoustics of coaxial rotors

Experimental Study to Quantify the Rotor-to-Rotor Interaction Characteristics of a Small Unmanned-Aerial-Vehicle

Impact of Rotor-to-Rotor Interactions on the Tonal Noise Characteristics of Different Octocopter Configurations

Investigation on Aerodynamic Noise Characteristics of Coaxial Rotor in Hover

Aerodynamic and Acoustic Analysis of Multiple Rotors in Different Configurations

Aeroacoustic and aerodynamic measurements at the rotor plane in the interaction of a small rotor with wings

An Investigation of the Noise Characteristics of a Small-Scale Rotor in Axial Descent

Numerical investigation on aerodynamic noise of rigid coaxial rotor in forward flight with lift-offset

Experimental investigation on acoustics and efficiency of rotor configurations for electric aerial vehicles

A Computational Aeroacoustic Study of a Multi-Rotor Powered Urban Air Mobility Vehicle

Numerical studies on small rotor configurations with validation using acoustic wind tunnel data

Numerical Investigation of Airfoilrotor Interaction at Low Reynolds Number

Active Noise Control Experiment for Unmanned Aerial Vehicle Propeller

Computational Investigation of Noise Interaction for a Nano Counter-Rotating Rotor in a Static Condition

An experimental investigation of noise characteristics of overlapping propellers

An Investigation of Multi-rotor Drone Noise Based on the Acoustic Hemisphere in an Actual Environment

Experimental study on noise reduction of a wavy multi-copter rotor

Experimental study on noise reduction of multi-rotor by phase synchronization

Noise measurement of a quadrotor drone in an anechoic chamber

Computational Investigation of Blade–Vortex Interaction of Coaxial Rotors for Evtol Vehicles

An efficient hybrid aeroacoustic method to predict the noise of a ducted coaxial-rotor UAV