Abstract:The performance of multiphase flow processes is often determined by the distribution of phases inside the equipment. However, controllers in the field are typically implemented based on flow variables, which are simpler to measure, but indirectly connected to performance (e.g., pressure). Tomography has been used in the study of the distribution of phases of multiphase flows for decades, but only recently, the temporal resolution of the technique was sufficient for real-time reconstructions of the flow. Due to the strong connection between the performance and distribution of phases, it is expected that the introduction of tomography to the real-time control of multiphase flows will lead to substantial improvements in the system performance in relation to the current controllers in the field. This paper uses a gas-liquid inline swirl separator to analyze the possibilities and limitations of tomography-based real-time control of multiphase flow processes. Experiments were performed in the separator using a wire-mesh sensor (WMS) and a high-speed camera to show that multiphase flows have two components in their dynamics: one intrinsic to its nonlinear physics, occurring independent of external process disturbances, and one due to process disturbances (e.g., changes in the flow rates of the installation). Moreover, it is shown that the intrinsic dynamics propagate from upstream to inside the separator and can be used in predictive and feedforward control strategies. In addition to the WMS experiments, a proportional-integral feedback controller based on electrical resistance tomography (ERT) was implemented in the separator, with successful results in relation to the control of the distribution of phases and impact on the performance of the process: the capture of gas was increased from 76% to 93% of the total gas with the tomography-based controller. The results obtained with the inline swirl separator are extended in the perspective of the tomography-based control of quasi-1D multiphase flows.

Research on tomography system for ultrasonic process of particle two-phase flow based on adaptive filtering

Application of the phase-averaged pre-processing method in identification of oscillatory two-phase flow patterns based on textural features

Detection of Particle Mass Flowrate in High-Speed Fluidization Based on Acoustic Emission Technology

Terahertz process tomography using in multiphase flow measurement

Research on the Particle Image Velocimetry for Two-Phase Flow

Optical Process Tomography Technology and the Prototype System

Frequency Domain Synthetic Aperture Focusing Technique for Variable-Diameter Cylindrical Components.

Ultrasonic Simulation Research of Two-Dimensional Distribution in Gas-Solid Two-Phase Flow by Backscattering Method

Adaptive Wavelet Thresholding Based Ultrasonic Signal Denoising

Investigation Of Microwave Tomographic Imaging Techniques For Industrial Processes

Self-Adaptive Beamforming Method Based on Plane Wave Ultrasound Imaging

Optical Tomography for Two Phase Flow Measurement

Wavenumber-Domain Fast Reconstruction Technique Using Ultrasonic Scanning for Transverse Wave Imaging

Simulations of Acoustic Tomography Using A Particle Filter

Sequential Dynamic Aperture Focusing Strategy for Transmissive Ultrasonic Phase Array Tomography

Whole flow field digital particle image velocimetry technology for microfluidic device

Ultrasonic Phased Array Process Tomography System for Multiphase Medium Imaging

A Method Combining Measurement Tool and Numerical Simulation for Calculating Acoustic Signals of Ultrasonic Flowmeter

Towards Tomography-Based Real-Time Control of Multiphase Flows: A Proof of Concept in Inline Fluid Separation

Confirming gas-solid flow pattern in tube with spectrum-tomography identification technology

Phase Distribution Measurement of Liquid–Solid Media Using Multimode Ultrasound