Abstract:Plant breeding programs and a wide range of plant science applications would greatly benefit from the development of in-field high throughput phenotyping technologies. In this study, a terrestrial LiDAR-based high throughput phenotyping system was developed. A 2D LiDAR was applied to scan plants from overhead in the field, and an RTK-GPS was used to provide spatial coordinates. Precise 3D models of scanned plants were reconstructed based on the LiDAR and RTK-GPS data. The ground plane of the 3D model was separated by RANSAC algorithm and a Euclidean clustering algorithm was applied to remove noise generated by weeds. After that, clean 3D surface models of cotton plants were obtained, from which three plot-level morphologic traits including canopy height, projected canopy area, and plant volume were derived. Canopy height ranging from 85th percentile to the maximum height were computed based on the histogram of the z coordinate for all measured points; projected canopy area was derived by projecting all points on a ground plane; and a Trapezoidal rule based algorithm was proposed to estimate plant volume. Results of validation experiments showed good agreement between LiDAR measurements and manual measurements for maximum canopy height, projected canopy area, and plant volume, with R2-values of 0.97, 0.97, and 0.98, respectively. The developed system was used to scan the whole field repeatedly over the period from 43 to 109 days after planting. Growth trends and growth rate curves for all three derived morphologic traits were established over the monitoring period for each cultivar. Overall, four different cultivars showed similar growth trends and growth rate patterns. Each cultivar continued to grow until ~88 days after planting, and from then on varied little. However, the actual values were cultivar specific. Correlation analysis between morphologic traits and final yield was conducted over the monitoring period. When considering each cultivar individually, the three traits showed the best correlations with final yield during the period between around 67 and 109 days after planting, with maximum R2-values of up to 0.84, 0.88, and 0.85, respectively. The developed system demonstrated relatively high throughput data collection and analysis.

Measurement of plant height based on stereoscopic vision under the condition of a single camera

Non-Destructive Measurement of Three-Dimensional Plants Based on Point Cloud

Vegetable Size Measurement Based on Stereo Camera and Keypoints Detection

Crop Height Measurement System Based on 3D Image and Tilt Sensor Fusion

3D reconstruction technology of the cotton image based on binocular vision

3D Imaging of Greenhouse Plants with an Inexpensive Binocular Stereo Vision System

In-field High Throughput Phenotyping and Cotton Plant Growth Analysis Using LiDAR

Field Estimation of Maize Plant Height at Jointing Stage Using an RGB-D Camera

Stereo-vision-based crop height estimation for agricultural robots

Monitor Geomatical Information of Plant by Reconstruction 3D Model Based on Kinect V2

Multispectral imaging and unmanned aerial systems for cotton plant phenotyping

Three-Dimensional Reconstruction of Soybean Canopy Based on Multivision Technology for Calculation of Phenotypic Traits

Measurement of 3-D Locations of Ripe Tomato by Binocular Stereo Vision for Tomato Harvesting

Research on automatic 3D reconstruction of plant phenotype based on Multi-View images

Dynamic detection of three-dimensional crop phenotypes based on a consumer-grade RGB-D camera

Automatic inter-plant spacing sensing at early growth stages using a 3D vision sensor

A UAV-Based Single-Lens Stereoscopic Photography Method for Phenotyping the Architecture Traits of Orchard Trees

Machine Vision System for 3D Plant Phenotyping

The Development of a Stereo Vision System to Study the Nutation Movement of Climbing Plants

Three-dimensional Location of Tomato Based on Binocular Stereo Vision for Tomato Harvesting Robot

Automatic Non-Destructive Growth Measurement of Leafy Vegetables Based on Kinect