Abstract:Noise from rail transit viaducts often has a negative effect on surrounding buildings and nearby residents. To reduce the bridge vibration and radiated noise, floating slab tracks have been widely adopted in rail transit viaducts. To calculate the vibration of coupled track-bridge systems, both time-domain and frequency-domain methods can be applied although their relative performance is not very clear. This study aims to compare the two approaches and then provide some guidelines in choosing the appropriate method for predicting the vibration. The principle and methodology of the two calculation methods are firstly introduced, and the models for the train, floating slab track and bridge are developed using similar parameters. To further improve the efficiency and accuracy of the frequency-domain method, a half period method and a weighted average method are proposed to calculate the average responses of a certain point on the rail, floating slab and bridge to approximate the response during the pass-by. An indirect method is used to estimate the wheel–rail combined roughness from the measured rail acceleration when the train is running on the bridge, and compared with the direct measurement rail roughness. For the vibration of the bridge and floating slab, comparisons are made between results obtained from the time-domain and frequency-domain methods with different train speeds, and between results from experiment and simulation with different roughness. It is found that the wheel–rail contact forces and other structural responses from the two approaches show good consistency in the frequency region above 20 Hz. It is shown that a good approximation of the response during the pass-by can be obtained using the frequency-domain method by adopting the half period average or a simplified weighted average of two wheel position cases. When using the measured roughness and estimated roughness, the simulated vibration of the floating slab and bridge match well with the experimental results, and the indirect method can be used to modify direct measurement roughness in lower frequency regions. In the vibration prediction, the rail vibration or roughness, and other parameters in the vehicle–track–bridge system, should be measured accurately to ensure high reliability.

Vibration analysis of concrete bridges during a train pass-by using various models

Research on computational method and dynamic characteristics of traffic vibration of steel bridge

Simulation Vibration Analysis of Train and Railway Continuous Steel Truss Bridge

Comparison of time-domain and frequency-domain models for vibration prediction of a rail transit viaduct paved with floating slab track

Investigation of the effect of vibration-reducing tracks on the vibration and noise from a large-span steel bridge

Study of Ground Vibration Caused by High-Speed Trains Through Bridges Based on Finite Element Model: Test Validation

Theoretical analysis of low-frequency noise radiated from bridge vibrations

Analysis of Bridge-Ground Vibrations Induced by Moving Loads of High-Speed Train

Train–Bridge Coupled Vibration of a Long-Span Steel Truss Suspension Bridge Under Complex Driving Conditions

Analysis on Environment and Building Vibration Induced by Passing Trains on Bridge Structures

Analysis of Train-Track-Bridge Coupling Vibration Characteristics for Heavy-Haul Railway Based on Virtual Work Principle

Modal Analysis of a Bridge During High-Speed Train Passages by Enhanced Variational Mode Decomposition

Comparison of Different Modeling Approaches and Their Influence on the Dynamic Calculation of Four Single-Span Railway Bridges

A Hybrid Solution for Studying Vibrations of Coupled Train–track–bridge System

Research on Mathematical Modelling and Analysis Mothod of Vehicle-bridge Coupled Vibration

Dynamic analysis of train and bridge in crosswinds based on a coupled wind-train-track-bridge model

Prediction and mitigation analysis of ground vibration caused by running high-speed trains on rigid-frame viaducts

Vertical Dynamic Analysis of a Bridge During a Heavy Haul Train Passing Through

Dynamic Performance Analysis of a High-Speed Railway Bridge Under Train Actions Using Operational Modal Parameters

Frequency-domain method for non-stationary stochastic vibrations of train-bridge coupled system with time-varying characteristics

Comparison of three kinds of dynamic finite-element models