Aerodynamic and aeroacoustic measurements of a landing gear torque link

Sarah Windiate,O. Stalnov,D. Angland,Xin Zhang,R. Ashworth

DOI: https://doi.org/10.2514/6.2013-2537

2013-06-24

Abstract:Aerodynamic and aeroacoustic measurements were performed on a 1/3-scale landing gear torque link model, comprised of a generic strut and torque link. The objective was to provide an aerodynamic and aeroacoustic experimental database for CFD validation for a torque link with varying torque angle and yaw angle, with the future objective being noise attenuation. Torque link angles of θ = 90◦, 110◦ and 130◦ and yaw angles of 0◦ ≤ φ ≤ 180◦ were tested. The Reynolds number ranged from 6.5 × 10 ≤ Re ≤ 2.7 × 10, based on the strut diameter. A torque link angle of θ = 130◦ resulted in the strut and torque link behaving as a single bluff body with reduced drag and suppressed vortex shedding from the strut. However, no discernable decreases in local noise source levels were recorded for varying the torque link angle. Increasing the yaw angle from φ = 0◦ resulted in several different flow regimes, with a suppression in vortex shedding for 90◦ ≤ φ ≤ 150◦. At 2 kHz, phased microphone array measurements showed interaction noise to dominate any additional noise caused by extending the torque arms into the freestream. At the optimal yaw angle of φ = 90◦, drag levels were 72% higher than the baseline case of φ = 0◦ and local noise source levels were lower over the 2 kHz ≤ f ≤ 8 kHz frequency range.

Physics