Abstract:A Discrete Element Method (DEM), a computerized testing rig and a soil bin were used to explain soil profile deformation caused by mouldboard plough. By using DEM, the motion of particles is given by collisions between particles. Soil-tillage tool interaction simulation was established by a 3D geometry of a mouldboard plough created using PTC Creo Parametric 3D Modelling software and soil bed modeled by discrete element particles using EDEM software. A bond element was introduced between particles and cohesion of soil was formed to create a simulation of the actual cohesive soil. The horizontal and vertical forces and soil disturbance in terms of bulk density at different speeds and depths were investigated. However, the simulation experiments followed the field experiments which were conducted using a computerized testing rig. Further, reaction forces on the plough and the resulting bulk densities were estimated from the simulated results and compared with the actual results from the field. Also, the accuracy of the developed model to predict soil displacement was measured and compared with the soil bin data with the average relative error of 1.317%. The simulated results of horizontal, vertical forces and bulk density matched well with the results obtained in the field experiment with the relative error of 4.435, 3.029 and 3.119% respectively. The vertical force provided the best regression results of 0.9948 <math>R2</math> with <math>RMSE</math> of 0.5964, followed by 0.9884 <math>R2</math> with <math>RMSE</math> of 0.4089 and 0.8391 <math>R2</math> with <math>RMSE</math> of 0.5441 for horizontal force and bulk density respectively. All regression results were obtained at <math>p<0.05</math>. The ANOVA test showed that the p-values for the horizontal force, vertical force and bulk density were 0.753, 0.695 and 0.025 respectively. There was no significant difference between the simulation and experiment results for cutting forces while there was a significant difference for the bulk density at <math>p<0.05</math>. This model can be applied as an accurate, consistent and fast method of effective prediction of the final soil condition and forces needed for tillage operation.

Effect of soil particle-size distribution (PSD) on soil-subsoiler interactions in the discrete element model

Effect of soil particle size on soil-subsoiler interactions using the discrete element method simulations

Simulation of Front End Loader Bucket–soil Interaction Using Discrete Element Method

The Influence of Particle-Size Distribution on Critical State Behavior of Spherical and Non-Spherical Particle Assemblies

DEM simulation of effects of particle size distribution on meso-mechanical properties of slip zone soil

Modeling the interaction of soil and a vibrating subsoiler using the discrete element method

Prediction of cutting forces and soil behavior with discrete element simulation

Analysis of the movement behaviour of soil between subsoilers based on the discrete element method

Discrete element simulations and experiments of soil disturbance as affected by the tine spacing of subsoiler

Effect of Particle Size Distributions (PSDs) on ground responses induced by tunnelling in dense coarse-grained soils: A DEM investigation

Simulation on dynamic behavior of dry soil ahead of the bulldozing plate with different cutting angles by DEM

Determination of discrete element model parameters for a cohesive soil and validation through narrow point opener performance analysis

Simulation of dynamic behavior of soil ahead of the bulldozing plates with different surface configurations by discrete element method

Defining the effect of sweep tillage tool cutting edge geometry on tillage forces using 3D discrete element modelling

Tillage force and disturbance characteristics of different geometric-shaped subsoilers via DEM

DEM parameters of slope cultivated purple soil in Southwest China and interaction mechanism between very narrow tine

Comparison of Two Subsoiler Designs Using the Discrete Element Method (DEM)

Prediction of precise subsoiling based on analytical method, discrete element simulation and experimental data from soil bin

Interaction between soil and a wide cutting blade using the discrete element method

Three-dimensional discrete element modelling of tillage: Determination of a suitable contact model and parameters for a cohesionless soil

Discrete element modeling of cultivator sweep-to-soil interaction: Worn and hardened edges effects on soil-tool forces and soil flow