Abstract:Previous studies have shown that biocement, or microbially induced calcite precipitation, can improve the mechanical behaviour of clean sand. However, the behaviour of biocemented sand is affected by several factors. In this paper, triaxial consolidated drained tests and K0 consolidation tests were carried out on sands (Ottawa sand, ASTM graded) with varying biocement treatment passes and relative densities to study the failure and drained stress–strain behaviour and compressibility of biocemented sand. It is found that for loose and medium dense sands, the slight biocement treatment on sand can be as good as or better than the densification treatment in terms of the strength improvement and the deformation control. In the triaxial tests, the shear strength, the slope of failure line in p’-q plane and the peak dilation rate increase with the increase in treatment passes at various levels of relative density. For the loose sand (Dr = 30%), 2-pass biocement treatments (1.0% calcite content) are sufficient to achieve a shear strength, a slope of failure line and a peak dilation rate higher than or similar to that of untreated dense sand (Dr = 90%), and for the medium dense sand (Dr = 50%), 1-pass biocement treatment (0.79% calcite content) is sufficient. In the K0 consolidation tests, the axial strain of the sand decreases with the increasing treatment passes. For medium dense sand (Dr = 50%), 1-pass treatment can control the axial strain to a level similar to that of untreated dense sand (Dr = 90%). The variation of K0 value versus axial strain during K0 consolidation for the biocemented sand shows a different pattern compared with the untreated sand, due to the presence of biocementation effect. Biocemented sand shows a smaller K0 value than the corresponding untreated sand at the final state of the K0 consolidation tests. Scanning electron microscopy was also conducted on the sand samples to investigate the particle-level structure of the biocemented sand and its correlations to the mechanical behaviour.

Influence of Sand Content on Secondary Consolidation Characteristics of Sand–Fine Mixtures

Interactive Influence of Water and Fines Contents on the Strength of Compacted Cement-Stabilized Clayey Sands: Insights and Predictive Framework

Influences of fines content on cyclic resistance ratio of fines-sand-gravel mixtures

Effect of Fines Content on the Compression Behavior of Calcareous Sand

Experiment of initial relative density effects on sand strength

Secondary Compression Behavior of Over-Consolidated Soft Clay after Surcharge Preloading

Experimental study on influences of fines content and consolidation stress on shear modulus and damping ratio of saturated sand

Degradation effect of seawater on the long-term dynamic behavior of artificially cemented sand

Experimental Study on Dynamic Characteristics of Saturated Remolded Soft Clay with Sand Particles

RESEARCH OF DYNAMIC PROPERTIES CHANGES AND MICROSCOPIC MECHANISM OF AGEING SAND

The Influence of Undrained Cyclic Loading Patterns and Consolidation States on the Deformation Features of Saturated Fine Sand over a Wide Strain Range

Compressibility and Permeability of Sand-Silt Tailings Mixtures

Influences of particle size distribution and fines content on the excess pore water pressure generation of sand-silt mixtures under cyclic loading

Experimental study on the effects of water content on the compression characteristics and particle breakage of calcareous sand

Experimental Study on the Time-Dependent Oedometric Compression Behavior of Calcareous Sand

Exploring Packing Density, Critical State, and Liquefaction Resistance of Sand-Fines Mixture Using DEM

Combined Influences of Cement, Rice Husk Ash and Fibre on the Mechanical Characteristics of a Calcareous Sand

Mechanical Behaviour of Biocemented Sands at Various Treatment Levels and Relative Densities

High-Strain Rate Compressive Behavior of Dry Mason Sand Under Confinement

One-Dimensional Compression Behavior of Calcareous Sand and Marine Clay Mixtures

Experimental Investigation into Limit Void Ratio Characteristics of Calcareous Sands considering Various Factors