Abstract:Oil and gas production in permafrost can effectively alleviate energy tensions. However, ice melting around wellbores and the accompanying wellhead instability affect the efficiency and safety of oil and gas development in permafrost. Moreover, the potential oil and gas leakage will damage the environment and the ecology of permafrost. Unfortunately, ice melting, formation subsidence, and wellhead behavior during this process have rarely been investigated in previous studies. In the present work, mechanical properties of permafrost were first experimentally investigated, which provided the basic parameter for subsequent numerical simulation. It was found that the ultimate strength gradually increased with the decreasing temperature, as well as the increasing confining pressure. Meanwhile, although the elastic modulus increased with decreasing temperature, it was less affected by confining pressure. Unlike other parameters, the Poisson's ratio was hardly affected by temperature and confining pressure. Moreover, both the internal friction angle and the cohesion increased with decreasing temperature, but the influence degree varied within different temperature ranges. Then, ice melting, formation subsidence, and the instability behavior of the wellhead caused by the disturbance of the development operation were numerically explored. The investigation results show that the ice melting range in the reservoir section reached 8.06 m, which is much wider than that in other well sections. Moreover, failure of the cement–permafrost interface, caused by ice melting, resulted in a wellhead sinking of up to 1.350 m. Finally, the insulation effect of the vacuum-insulated casing showed that the temperature drop of the designed vacuum-insulated casing was much lower than that of the ordinary casing. When the fluid temperature within the wellbore was 70 °C, the temperature drop of the designed vacuum-insulated casing was 3.54 °C lower than that of the ordinary casing. This study provides support for maintaining wellhead stability during oil and gas extraction in permafrost for avoiding some environmental disasters (such as oil and gas leakage).

Numerical simulation study on the action law of low-temperature drilling fluid intrusion into rock formation in polar drilling

Simulation of Drilling Temperature Rise in Frozen Soil of Lunar Polar Region Based on Discrete Element Theory

Stability Analysis of Borehole Walls When Drilling with Normal-Temperature Drilling Fluids in Permafrost Strata

Dynamic mechanical behavior of frozen soil using smoothed particle hydrodynamics

Numerical simulation of the freezing process of concrete

A Fully Thermo-Hydro-Mechanical Coupling Simulation at Low Temperature in Underground LNG Storage

Preliminary Insight into Ice Melting, Surface Subsidence, and Wellhead Instability during Oil and Gas Extraction in Permafrost Region

Numerical Modeling of Thermal Behavior during Lunar Soil Drilling

A Transient Analytical Model for Predicting Wellbore/Reservoir Temperature and Stresses during Drilling with Fluid Circulation

Mechanical analysis of frost heaving of weakly cemented soft rock tunnels in cold regions

Thermo‐hydro‐mechanical coupled material point method for modeling freezing and thawing of porous media

Numerical Simulations of Failure Mechanism for Silty Clay Slopes in Seasonally Frozen Ground

Numerical simulation of fracture propagation in freezing rocks using the extended finite element method (XFEM)

Research on the Effect of Crucial Parameters on Ice Borehole Deformations Using a Proposed Computation Model

Thermo-mechanical coupling analysis and software development

Finite element modeling of thermal‐hydro‐mechanical coupled processes in unsaturated freezing soils considering air‐water capillary pressure and cryosuction

Numerical simulation of frost heave of saturated soil considering thermo‐hydro‐mechanical coupling

Probabilistic Analysis of the Frozen Depth of Soil Foundations Considering Thermal and Hydraulic Coupling by COMSOL

A fully coupled thermo-hydro-mechanical model for fractured rock masses in cold regions

Dynamic Simulation Method for Low-permeability Reservoirs with Fracturing-flooding Based on a Dual-Porous and Dual-Permeable Media Model

Analytical Model of Hydraulic Fracturing for Low Permeability Hot Dry Rock Reservoirs and DEM Simulation Base on Fluid-Solid Coupling