Abstract:Big data provide massive samples and resources for exploring the operating rules of public transportation. This article proposes a method that combines multiple data sources to identify potential bus passenger flows, aiming to address the issue of insufficient identification accuracy with a single data source. First, the spatially weighted K‐means algorithm and improved DBSCAN algorithm are designed to partition traffic zones and residents' travel flow OD is extracted based on mobile phone signaling data. Second, using bus IC card data and vehicle trajectory data, a method for identifying bus passenger boarding and alighting stops based on spatiotemporal clustering is proposed and the bus passenger flow OD for each traffic zone is calculated. By comparing the resident travel flow OD with the bus passenger flow OD, we set a threshold for the potential bus passenger demand proportion. Finally, the analysis is conducted using actual data from a city in central China. The city is divided into 43 traffic zones, with the maximum bus passenger flow proportion between zones being 14.9%, the minimum being 5.0%, and the average being 7.2%. The initial threshold for the potential bus passenger demand proportion is thus set to 7.2%, and a sensitivity analysis is conducted by gradually decreasing the threshold in increments of 0.5% to 6.7%, 6.2%, 5.7%, and 5.2%. The corresponding potential bus passenger demand OD pairs between traffic zones are identified as 419, 358, 245, 151, and 51. Urban managers should focus on the 51 pairs with relatively large potential flows to gradually optimize and balance the development of the bus network based on actual conditions. The method proposed provides important theoretical and practical support for effectively optimizing urban bus networks. However, there are limited indicators for identifying potential passenger flows; in the future, more multidimensional indicators will be taken into consideration.

A sampling scheme for quantifying and benchmarking on time performance of urban bus transit

Wheres the Bus: Examining Factors Correlated with High and Low Public Transit On-Time Performance

A Data-Driven and Optimal Bus Scheduling Model with Time-Dependent Traffic and Demand

Mixed Scheduling Strategy for High Frequency Bus Routes with Common Stops

Public Transit Bus Travel Time Variability Analysis Using Limited Datasets: A Case Study

Toward Sustainable Transit Operations and Performance Enhancement Using Archived Automatic Vehicle Location Data

Exploring the drive-by sensing power of bus fleet through active scheduling

Route selection for real-time air quality monitoring to maximize spatiotemporal coverage

Real-time Arterial Performance Measurement Using Signal Timing Data and BRT As Probes

Data-Driven Optimization of Public Transit Schedule

Self-Calibrated Transit Service Monitoring Using Automated Collected Data

Use of High-Resolution Signal Controller Data to Measure Transit Signal Priority Performance: A Case Study in the Boston Region

Measure Dynamic Individual Spatial-Temporal Accessibility by Public Transit: Integrating Time-Table and Passenger Departure Time

Customized Commuting Bus Route and Timetable Optimization Using Mobile Internet Data

Assessing public transit performance using real-time data: spatiotemporal patterns of bus operation delays in Columbus, Ohio, USA

An Efficient Approach for Identifying Potential Bus Passenger Demand Based on Multisource Data

Study of Bus Passenger Origin-Destination and Travel Behavior Using Automated Data Collection Systems in London

Real-time arterial performance measurement using BRT probe data and signal timing data

High volume bus stop upstream average waiting time for working capacity and quality of service

Big Data Analysis for Travel Time Characterization in Public Transportation Systems

Analyzing travel time reliability of a bus route in a limited data set scenario: A case study