Abstract:Since the launch of Sputnik in 1958, thousands of satellites have been launched by governments and commercial entities for a wide range of purposes. Once a satellite has completed its primary mission, most operators de-orbit or move the satellite into a graveyard orbit as to avoid collisions with active satellites. However, some spacecraft do not have any residual propellant. Other satellites suffer failures and become hazards themselves. Non-operational satellites in orbit have become an increasing collision risk for operational satellites and this problem will only become worse as the number of satellites launched every year increases. Although finding ways to clean up orbital debris is important, near term solutions is needed to mitigate the risk of debris colliding with an active satellite. Traditionally, debris avoidance is performed by operators on the ground who calculate debris conjunctions and analyze the risk of moving the satellite. This paper proposes an alternate solution where the process of analyzing and avoiding orbital debris can be done autonomously by the satellite without human intervention. This provides advantages such as reducing the number of operators needed to maintain a satellite or a large constipation of satellites thus reducing operating costs. With the increased amount of processing power on modern satellites, this system is possible with current technology. The system would first collect a database of two line element's (TLE) for each piece of orbital debris. The satellite will then perform a conjunction analysis against each piece of debris and the satellites predicted future position. The satellite will re-assess these probabilities at set increments as it gets closer to the conjunction, or when the debris database is updated. The satellite operator will be able to set the collision probability threshold. If this threshold is exceeded, the satellite will calculate the most efficient maneuver based off the required delta v, time to the conjunction and staying in its operational orbit. The system will also attempt to combine any required avoidance burns with a normal orbit maintenance burn to minimize fuel consumption. When an appropriate avoidance burn is being considered, the system will check for debris conjunctions in this new orbit. If there is no danger of a collision, the maneuver will be executed.

Towards a second life for Zombie Satellites: Anomaly occurrence and potential recycling assessment

End to End Satellite Servicing and Space Debris Management

Considerations for Eco-LeanSat Satellite Manufacturing and Recycling

A Population Dynamics Approach to the Distribution of Space Debris in Low Earth Orbit

Advanced Inflatable De-Orbit Solutions for Derelict Satellites and Orbital Debris

Defunct Satellites in Nearly Polar Orbits: Long-term Evolution of Attitude Motion

A Preliminary Study on Dead Geostationary Satellite Removal

Mission lifetime optimisation with self or assisted disposal

Building Small-Satellites to Live Through the Kessler Effect

Spacecraft design optimisation for demise and survivability

Statistical Analysis of LEO and GEO Satellite Anomalies and Space Radiation

An autonomous satellite debris avoidance system

Satellite Capture and Servicing Using Networks of Tethered Robots Supported by Ground Surveillance

Theoretical studies on space debris recycling and energy conversion system in the International Space Station

De-orbiting Small Satellites Using Inflatables

Instability of the present LEO satellite populations

Characterization of Deorbiting Satellites and Space Debris with Radar

On the Automation, Optimization, and In-Orbit Validation of Intelligent Satellite Constellation Operations

Space debris removal – Review of technologies and techniques. Flexible or virtual connection between space debris and service spacecraft

Design of the Propulsion System of Nano satellite: StudSat2