Abstract:Objective: The aim was to systematically compare the drug compatibility with various closed intravenous (i.v.) infusion containers, to provide a reference for selecting a relatively superior infusion container and improve the medication safety for patients in clinical practice. Methods: The compatibility of four commonly used clinical injections (ceftazidime, pantoprazole sodium, ambroxol hydrochloride, edaravone) with three representative closed i. v. infusion containers (non-PVC infusion bags, upright polypropylene infusion bags, inner sealed polypropylene infusion bags) prefilled with infusion fluids (0.9% sodium chloride or 5% dextrose) in the Chinese market were investigated in this study. The particle counts of both infusion fluids and diluted chemical injections by infusion fluids in various infusion containers were determined by the light obscuration method. At 0, 2 and 6 h after four injections following dilution with infusion fluids in each container, the pH of the solutions was detected, and the physical properties were examined by visual inspection. Meanwhile, the drug concentrations were assessed by high performance liquid chromatography (HPLC). Results: As for either infusion fluids or diluted injections by infusion fluids, the particle counts in non-PVC infusion bags were significantly greater than those in the other two bags under some circumstances. The particle counts in diluted injections by infusion fluids increased dramatically compared with those in infusion fluids in all infusion containers, especially for the small-size particles. But pH, physical properties and drug concentrations of diluted infusion solutions in all infusion containers remained nearly unchanged over the test period. Conclusion: Closed i. v. infusion containers included in this study are all well-compatible with four injections. Moreover, the closed infusion containers produced by Chinese manufacturers have met the international quality standard. Particularly, the intravenous admixture preparation process needs to be optimized to reduce the overall particulate contaminants.

Clinical significance of insulin adsorption by polyvinyl chloride infusion systems

Insulin adsorbance to polyvinylchloride (PVC) surfaces of fluid container and infusion-set

Evaluation of regular insulin adsorption to polypropylene bag and polyvinyl chloride infusion set

The effect of tubing dwell time on insulin adsorption during intravenous insulin infusions

In vitro assessment of the influence of intravenous extension set materials on insulin aspart drug delivery

Availability of Insulin From Parenteral Nutrient Solutions

Insulin Instability in Parenteral Nutrition Admixtures

Percent recovery of insulin from two different concentrations (3 U/250 mL and 45 U/250 mL) of regular insulin solutions prepared for continuous rate infusion

Diazepam sorption to PVC- and non-PVC-based tubes in administration sets with quantitative determination using a high-performance liquid chromatographic method

Quantitative analysis of insulin in total parenteral nutrition bag in Taiwan

Nitroglycerin Adsorption to a Combination Polyvinyl Chloride, Polyethylene Intravenous Administration Set

Insulin Loss in Parenteral Nutrition Systems

Effect of tubing length on adsorption of diazepam to polyvinyl chloride administration sets.

Critical parameters in drug delivery by intravenous infusion

Availability of Insulin from Total Parenteral Nutrition Solutions

Assessment of subcutaneously administered insulins using in vitro release cartridge: Medium composition and albumin binding

A Portable System for Continuous Intravenous Insulin Delivery: Characteristics and Results in Diabetic Patients

Determinants of Insulin Availability in Parenteral Nutrition Solutions

Drug compatibility with various closed intravenous infusion containers

Stability of diluted adenosine solutions in polyvinyl chloride infusion bags