Multi-Objective Optimization towards Heat Dissipation Performance of the New Tesla Valve Channels with Partitions in a Liquid-Cooled Plate

Liang Xu,Hongwei Lin,Naiyuan Hu,Lei Xi,Yunlong Li,Jianmin Gao

DOI: https://doi.org/10.3390/en17133106

IF: 3.2

2024-06-25

Energies

Abstract:The utilization of liquid-cooled plates has been increasingly prevalent within the thermal management of batteries for new energy vehicles. Using Tesla valves as internal flow channels of liquid-cooled plates can improve heat dissipation characteristics. However, conventional Tesla valve flow channels frequently experience challenges such as inconsistencies in heat dissipations and unacceptably high levels of pressure loss. In light of this, this paper proposes a new type of Tesla valve with partitions, which is used as internal channel for liquid-cooled plate. Its purpose is to solve the shortcomings of existing flow channels. Under the working conditions of Reynolds number equal to 1000, the neural network prediction-NSGA-II multi-objective optimization method is used to optimize the channel structural parameters. The objective is to identify the optimal structural configuration that exhibits the greatest Nusselt number while simultaneously exhibiting the lowest Fanning friction factor. The variables to consider are the half of partition thickness H, partition length L, and the fillet radius R. The study result revealed that the optimal parameter combination consisted of H = 0.25 mm, R = 1.253 mm, L = 0.768 mm, which demonstrated the best performance. The Fanning friction factor of the optimized flow channel is substantially reduced compared to the reference channel, reducing by approximately 16.4%. However, the Nusselt number is not noticeably increased, increasing by only 0.9%. This indicates that the optimized structure can notably reduce the fluid's friction resistance and pressure loss and slightly enhance the heat dissipation characteristics.

energy & fuels

What problem does this paper attempt to address?

This paper mainly discusses the optimization problem of liquid cooling plate heat dissipation performance in the thermal management of new energy vehicle batteries. The study proposes a new type of Tesla valve channel design with baffles, aiming to solve the problems of uneven heat dissipation and excessive pressure loss in traditional Tesla valve channels. Through neural network prediction-NSGA-II multi-objective optimization method, under the working conditions of Reynolds number 1000, the channel structure parameters (including half of the baffle thickness H, baffle length L, and corner radius R) are optimized to seek the optimal structural configuration that minimizes the Fanning friction factor while maximizing the Nusselt number.

The research results show that the optimal combination of parameters is H = 0.25 mm, R = 1.253 mm, L = 0.768 mm. The optimized channel Fanning friction factor is significantly reduced by about 16.4%, while the Nusselt number only increases by 0.9%. This indicates that the optimized structure can effectively reduce fluid resistance and pressure loss, and slightly improve the heat dissipation performance. The paper also compares different cooling methods, pointing out the advantages of liquid cooling in battery thermal management, and introduces the application potential of Tesla valves in microchannel structures.

The paper uses physical models and numerical simulation methods, and calculates the results through FLUENT software, verifying grid independence and result accuracy. The ultimate goal of the research is to provide guidance for the design of liquid cooling plate channels to improve the thermal management efficiency of battery systems.