Mechanical and fracture characteristics of single tunnel under the induced effect of a key joint
Fei Wang,Peng Zhang,Kaihui Li,Cong Wang,Pengfei Cui
DOI: https://doi.org/10.1007/s43452-023-00733-4
IF: 4.042
2023-07-20
Archives of Civil and Mechanical Engineering
Abstract:The existence of joint at key position will change the stress distribution law around the tunnel, thereby changing the strength and stability of the tunnel. Therefore, a series of uniaxial compression tests were performed on the single-holed samples containing a joint to explore the effect of key joint parameters, including joint inclination (0°, 30°, 45°, 60°, and 90°) and length (20, 30, 40, and 50 mm), on the mechanical and fracture characteristics of the tunnel. Meantime, the DIC equipment and box dimension method were used to analyze the surface strain field of the sample and quantitatively characterize the surface crack of the failed sample, respectively. The experimental results show the uniaxial compressive strength of samples reaches the maximum and minimum values at joint inclination angles of 0° and 60°, respectively, and the strength of samples is negatively correlated with the joint length. Interestingly, the existence of some key joints can help to improve the strength of the single-holed sample. The strain bands and cracks mainly develop around the joint and the tunnel, which is well explained by the stress distribution results calculated by COMSOL software. The numerical results show that with the increase of joint inclination, the tensile stress at the upper endpoint of circular hole is increasing, and the compressive stress at left and right endpoints of the hole slightly increases. Analyzing the relative positional relationship between the coalescence path and the tunnel, the failure modes of the sample with different joint inclinations are classified into three types: center-symmetric failure (0° and 90°), through-joint failure (30° and 45°) and axisymmetric failure (60°). Additionally, the box fractal dimension of the surface crack of failed sample at the peak stress is closely related to the failure mode of the sample, and the box fractal dimension of samples with the same failure mode is positively correlated with their peak stress.
engineering, mechanical,materials science, multidisciplinary, civil