Luminescence and Stability Enhancement of CsPbBr 3 Perovskite Quantum Dots through Surface Sacrificial Coating

Dong Huang,Jun Bo,Ronghong Zheng,Chengzhao Luo,Xiaojuan Sun,Qinyi Li,Dongyang Shen,Zhishuai Zheng,Mengyu Chen,Yixing Yang,Aiwei Tang,Song Chen,Yu Chen

DOI: https://doi.org/10.1002/adom.202100474

IF: 9

2021-05-18

Advanced Optical Materials

Abstract:<p>All‐inorganic perovskite quantum dots (QDs) have emerged as a new category of low‐cost semiconducting luminescent materials for optoelectronic applications. However, their poor stability has become the main challenge that impedes their potential applications. Herein, Ni‐doped CsPbBr₃ QDs with lead phosphate (Pb₃(PO₄)₂) shell through surface sacrificial coating (c‐Ni‐CsPbBr₃) have been developed based on a modified thermal injection approach. The synergistic effect of Ni doping and Pb₃(PO₄)₂ coating effectively improves the stability and optical performances of CsPbBr₃ QDs, including photoluminescence (PL) intensity, the average lifetime, and PL quantum yield (QY). Thus, the c‐Ni‐CsPbBr₃ QDs demonstrate the full width at half maxima (FWHM) and PLQY being 18.42 nm and 90.77%, respectively. The PL intensity of c‐Ni‐CsPbBr₃ can be maintained at 81% of its original value after being heated at 100 °C for 1 h. No phase transformation can be observed after being stored under ambient conditions (25 °C, 60% relative humidity (RH)) for 21 days. In addition, by combining green c‐Ni‐CsPbBr₃ QDs, red CdSe‐based QDs and the blue GaN chip, a QD enhancement film (QDEF) is fabricated to form a liquid crystal display (LCD) backlit with a wide color gamut covering cover 121% of the National Television System Committee (NTSC) standard.</p>

materials science, multidisciplinary,optics

What problem does this paper attempt to address?

The paper attempts to address the issues of stability and optical performance of all-inorganic perovskite quantum dots (CsPbX₃ QDs) in practical applications. Specifically:

1. **Stability Issues**:
- Perovskite quantum dots, due to their ionic nature, are prone to phase transitions or even decomposition under external stimuli such as radiation, heat, humidity, and oxygen.
- High defect density makes these quantum dots sensitive to structural and surface defects, thereby accelerating the degradation of their optoelectronic device performance.
- Due to the large specific surface area and abundant surface defect sites, inorganic perovskite quantum dots prepared by colloidal methods usually exhibit poor storage stability and are prone to aggregation.

2. **Optical Performance Issues**:
- Although perovskite quantum dots have high photoluminescence quantum yield (PLQY), narrow full width at half maximum (FWHM), strong defect resistance, long carrier lifetime, and tunable photoluminescence characteristics across the entire visible spectrum, existing surface passivation methods often affect their optical performance.

To address these issues, the paper proposes a method to enhance the stability and optical performance of CsPbBr₃ quantum dots through a surface sacrificial coating (Ni doping and Pb₃(PO₄)₂ shell). This method not only improves the photoluminescence intensity, average lifetime, and quantum yield of the quantum dots but also exhibits excellent stability under high temperature, high humidity, and aqueous environments.