Analysis of Inclusions and Impurities Present in Typical HPDC, Stamping and Extrusion Alloys Produced with Different Scrap Levels
Manel da Silva,Jaume Pujante,Joanna Hrabia-Wiśnios,Bogusław Augustyn,Dawid Kapinos,Mateusz Węgrzyn,Sonia Boczkal
DOI: https://doi.org/10.3390/met14060626
IF: 2.695
2024-05-26
Metals
Abstract:The European Green Deal poses a two-pronged challenge for the automotive industry: migrating to solutions based on light structures, requiring lightweight concepts and light materials, while at the same time avoiding dependence on the importation of these advanced materials. Aluminium alloys are lightweight and cost-effective materials that can successfully meet the requirements of many structural applications; however, their production requires bauxite and other Critical Raw Materials (CRMs), such as Si and Mg. Aluminium alloys are fully recyclable, but scrap is usually contaminated and its use is related to an increment of impurities, tramp elements and undesired inclusions. Traditionally, the use of secondary alloys has been restricted to low-performance applications. The present work analyses the effect that the use of scrap has on the quantity of inclusions present in the alloy and on other properties relevant for material processing. This study was carried out using common alloys associated with three of the most common aluminium processes used in the car manufacturing industry: high-pressure die casting (HPDC) (AB-43500), extrusion (6063) and sheet metal forming (5754 and 6181). The reference alloys were mixed with different levels of scrap (0, 20, 40, 60, 80 and 100%), with an aim to keep the chemical composition as unaffected as possible. The inclusion level of the alloy was characterized using the Prefil Footprinter® test. In addition, the obtained materials, after being cast in an open mould, were subjected to metallographic characterization. Relevant properties were measured to assess the processability of the alloys for the corresponding transforming process using the flowability test for the HPDC alloy and high-temperature compression for the extrusion alloys. The results obtained suggest that the number of inclusions present in the melt highly increase with the amount of scrap used to produce the alloy. These inclusions are also related to a significant loss of flowability, but do not have a noticeable impact on microstructure.
materials science, multidisciplinary,metallurgy & metallurgical engineering