Study on the Properties of Compound Surfactants with PO Groups

Biao Wang,Xue Wang,Futang Hu,Xiangyu Wang,Zhongji Yang,Xiuyu Zhu,Gen Li,Keliang Wang

DOI: https://doi.org/10.3390/en17020513

IF: 3.2

2024-01-21

Energies

Abstract:The compound surfactant system has considerable development prospects for improving oil recovery. A synergistic effect can be achieved through the orderly arrangement of the two surfactants on the interface, which can make up for the performance defects of a single surfactant. In this paper, the effects of the number of propylene oxides (PO) in composite surfactants on interfacial tension and emulsion stability were systematically studied. The results showed that the solubility of composite surfactants was significantly improved under high-salinity conditions by adding anionic–nonionic surfactants to a single anionic surfactant. The interfacial tension of composite surfactants shows a V-shaped change of first decreasing and then increasing with the increase in PO groups. As the number of PO groups increases, the emulsion first increases and then decreases. Among the series of composite surfactants, LBAS/C12PO10S has the lowest interfacial tension, reaching the order of 10−3 mN/m, and the emulsion formed by it exhibits superior stability. This indicates that the synergistic effect of the two surfactants can be improved by adjusting the number of PO groups. Furthermore, the LBAS/C12PO10S composite system can be mixed with crude oil to form Winsor III microemulsion, which has great potential for application in enhanced oil recovery via chemical flooding.

energy & fuels

What problem does this paper attempt to address?

This paper mainly discusses the properties of composite surfactants containing PO groups in enhancing oil recovery. The influence of the number of PO groups on the interfacial tension and emulsion stability of the composite surfactants was studied. The results showed that increasing the number of PO groups can significantly improve the solubility of the composite surfactants under high salt conditions, and the interfacial tension decreases first and then increases, while the emulsion stability increases first and then decreases. Among a series of composite surfactants, LBAS/C12PO10S showed the lowest interfacial tension (approximately 10^-3 mN/m) and excellent emulsion stability. This composite system can form Winsor III microemulsion when mixed with crude oil, and has great potential for chemical oil displacement. By adjusting the number of PO groups, the synergistic effect of the two surfactants can be optimized to compensate for the performance defects of a single surfactant. The experiment also involves the proportion of different surfactants, salt tolerance, microemulsion formation, and stability testing.