Abstract:An approach referred to as Mechanical Response Tissue Analysis (MRTA) has been developed for the noninvasive determination of mechanical properties of the constituents of the intact limb. Of specific interest in the present study is the bending stiffness of the ulna. The point mechanical impedance properties in the low frequency regime, between 60 and 1,600 Hz are used. The procedure requires a proper design of the probe for good contact of the skin at midshaft and proper support of the proximal and distal ends of the forearm to obtain an approximation to "simple support" of the ulna. A seven-parameter model for the mechanical response is then valid, which includes the first mode of anterior-posterior beam bending of the ulna, the damping and spring effect of the soft tissue between probe and bone, and the damping of musculature. A dynamic analyzer (HP3562A) provides in seconds the impedance curve and the pole-zero curve fit. The physical parameters are obtained from a closed-form solution in terms of the curve-fit parameters. The procedure is automated and is robust and analytically reliable at about the five percent level. Some 80 human subjects have been evaluated by this mechanical response system and by the Norland single photon absorptiometer, providing for the first time in vivo, a comparison of elastic bending stiffness (ulna) and bone mineral content (radius). Three functional parameters of potential clinical value are the cross-sectional bending stiffness EI, the axial load capability Pcr (Euler buckling load) and the bone "sufficiency" S, defined as the ratio of Pcr to body weight. The correlation between EI and bone mineral (r = 0.81) is only slightly less than previous in vitro results with both measurements on the same bone (r = 0.89). When sufficiency is taken into consideration, the correlation of Pcr and bone mineral content is improved (r = 0.89). An implication is that "quality" of bone is a factor which is not indicated by bone mineral content but which is indicated by stiffness. Bone mineral is necessary for proper stiffness but not sufficient. Therefore mechanical measurement should provide a new dimension to be used toward a better understanding of the factors related to bone health and disease.

Validating the measurement of passive Musculo-articular wrist stiffness without intentional or reactive contraction using axillary plexus block

Training Wrist Extensor Function and Detecting Unwanted Movement Strategies in an EMG-controlled Visuomotor Task.

The SE-AssessWrist for robot-aided assessment of wrist stiffness and range of motion: Development and experimental validation

Passive Wrist Stiffness: The Influence of Handedness

Quantitative Assessment of Biceps Brachii Muscle Stiffness by Using Young’s Modulus–angle Curve During Passive Stretching in Stroke Patients

Noninvasive determination of ulnar stiffness from mechanical response--in vivo comparison of stiffness and bone mineral content in humans

Quantifying Plantar Flexor Muscles Stiffness During Passive and Active Force Generation Using Shear Wave Elastography in Individuals With Chronic Stroke

Verification of Finger Joint Stiffness Estimation Method With Soft Robotic Actuator

Quantifying Active and Passive Stiffness in Plantar Flexor Muscles Following Intermittent Maximal Isometric Contractions Using Shear Wave Elastography

Acousto-elasticity of Transversely Isotropic Incompressible Soft Tissues: Characterization of Skeletal Striated Muscle

OroSTIFF: Face-referenced measurement of perioral stiffness in health and disease

Isokinetic and electromyographic characterization of ankle plantarflexors' hypertonia in people with multiple sclerosis

A Regression-Based Framework for Quantitative Assessment of Muscle Spasticity Using Combined EMG and Inertial Data from Wearable Sensors

Reliability of Bi-Axial Ankle Stiffness Measurement in Older Adults

Evaluation of Apparatus and Protocols to Measure Human Passive Neck Stiffness and Range of Motion

Performance of Passive Muscle Stiffness in Diagnosis and Assessment of Disease Progression in Duchenne Muscular Dystrophy

Analysis of interactive effect of stretch reflex and shortening reaction on rigidity in Parkinson's disease

Method for instrumentation of orthotic joints for measurement of internal joint loads

Quantitative Estimation of Passive Elastic Properties of Individual Skeletal Muscle in Vivo Using Normalized Elastic Modulus-Length Curve

Higher muscle passive stiffness in Parkinson's disease patients than in controls measured by myotonometry

Amplitude- and velocity-dependency of rigidity measured at the wrist in Parkinson's disease