Construction of a Photo-thermal-magnetic coupling reaction system for enhanced CO2 reduction to CH4

Naixu Li,Ying Tu,Ke Wang,Dongxiao Huang,Quanhao Shen,Wenshuai Chen,Jiancheng Zhou,Quanhong Ma,Maochang Liu,Naixu Li,Ying Tu,Ke Wang,Dongxiao Huang,Quanhao Shen,Wenshuai Chen,Jiancheng Zhou,Quanhong Ma,Maochang Liu

DOI: https://doi.org/10.1016/j.cej.2021.129940

IF: 15.1

2021-10-01

Chemical Engineering Journal

Abstract:Aiming at the bottleneck of thermodynamics, kinetics and reaction systems in photothermal catalytic CO2 reduction conversion, a three-field coupling method based on the efficient utilization of solar energy and the application of a photo-thermal-magnetic three-field was proposed to achieve efficient and highly selective CO2 conversion. The composite monolithic catalyst with three field response functions and multiple active reaction interfaces was prepared by using photoactive copper supported by nickel foam. The effect of an external alternating magnetic field on photocatalytic CO2 reduction was studied using a range between 0.005 and 0.1 wt% Cu/Cu2O/Ni(OH)2/NF as catalysts. The results showed that 0.01 wt% Cu/Cu2O/Ni(OH)2/NF exhibited the best catalytic activity and CH4 selectivity under alternating magnetic field enhanced photocatalysis. The main products were CO (6.76 μmol g−1) and CH4 (167 μmol g−1). The selectivity of CH4 was 96.1%. The yields of CH4 using this method were 11 and 6 times higher than the yields obtained with photocatalysis (14.58 μmol g−1) and magnetic-thermal catalysis (26.75 μmol g−1), respectively. According to the analysis of temperature measurements and electrochemical measurements, the surface temperature of the three-field coupled catalyst reaches about 230 °C. Applying an alternating magnetic field can effectively reduce the recombination of photogenerated electron holes. Alternating magnetic field enhanced photocatalytic CO2 reduction conversion provides a new and promising method for the efficient conversion and utilization of solar energy.

engineering, chemical, environmental

What problem does this paper attempt to address?

The paper attempts to address the bottlenecks in thermodynamics, kinetics, and reaction systems present in the photothermal catalytic reduction of carbon dioxide (CO2). Specifically, the paper focuses on the following major issues:

1. **Thermodynamic issues**: In the process of photocatalytic reduction of CO2, effective photons are mainly concentrated in the high-frequency range, while low-frequency photons cannot be effectively utilized.
2. **Kinetic issues**: The oxidation/reduction reaction rate on the catalyst surface is relatively slow, while the recombination rate of the subsequently generated photogenerated electron-hole pairs is fast, leading to low catalytic efficiency.
3. **Reaction system issues**: The heat required for the reaction cannot be continuously and efficiently supplied.

To solve these problems, the paper proposes a method based on the coupling of light, heat, and magnetic fields. By efficiently utilizing solar energy and applying light-heat-magnetic field coupling, efficient CO2 reduction to methane (CH4) is achieved. The specific method includes the preparation of composite integral catalysts with three-field response functions and multiple active reaction interfaces, and the study of the effect of external alternating magnetic fields on photocatalytic CO2 reduction. Experimental results show that the 0.01 wt% Cu/Cu2O/Ni(OH)2/NF catalyst exhibits the best catalytic activity and CH4 selectivity under the enhanced photocatalytic conditions of the alternating magnetic field, with a CH4 selectivity of 96.1% and a yield of 167 μmol g⁻¹, which are 11 times and 6 times higher than those of pure photocatalysis and magnetic thermal catalysis, respectively.