Abstract:The granular motion of binary-size mixture in a three-dimensional rotating drum operating in the rolling regime is numerically tracked via the discrete element method (DEM), with a focus on the axial dispersion behavior of the different particle types in response to the inherent size-segregation. Accordingly, the evolution with time, the frequency distribution and the space-time profiles of the axial dispersion coefficients are evaluated. The results demonstrate that (i) the fast radial segregation gives rise to the sharp increase and decrease of the axial dispersion coefficients of respectively the large and small particles in both the active and passive regions; (ii) the axial dispersion coefficients in the active region is an order-of-magnitude higher than that in the passive region; (iii) after the radial segregation, the frequency distributions of the axial dispersion coefficients of the large particles, the small particles and all the particles are normal distributions; (iv) the greatest axial dispersion coefficients of both particle types are at the upper part of the active region near the bed surface; (v) increasing the rotating speed and particle diameter ratio clearly enhances the axial dispersion intenstity in the active and passive regions; and (vi) axial segregation results in the greatest axial dispersion near the end walls, while most of the rest of the drum exhibit equally low axial dispersion. The results obtained here contribute towards understanding the dynamical response of the axial dispersion of different particle types to the inevitable radial and axial segregation phenomena, and are expected to be valuable for improving operations and advancing theoretical models of such granular systems with constituents of different sizes.

Evaluation of static and rolling friction coefficients of granulated sugar using the discrete element method in a rolling mode rotating drum

Studying on the Upper Limit of the Coarse-Grained DEM Model for Simulating Mixing Processes in a Rolling Drum with Complex Wall Boundary

Investigation of Modeling Non-Spherical Particles by Using Spherical Discrete Element Model with Rolling Friction

Numerical evaluation of the granular mixing behavior in a flighted rotary drum through the Discrete Element Method

Three-dimensional axial dispersion dynamics of granular flow in the rolling-regime rotating drum

An Experimentally Validated Coarse-Grain DEM Study of Monodisperse Granular Mixing

The importance of a velocity-dependent friction coefficient in representing the flow behaviour of a blade-driven powder bed

A new method for DEM simulation of dust-bearing granular flow – Modeling the effect of dust on the change in granule friction coefficient

A novel discrete model for granular material incorporating rolling resistance

DEM investigation of the axial dispersion behavior of a binary mixture in the rotating drum

Numerical investigation of the particle flow behaviors in a fluidized-bed drum by CFD-DEM

Modelling of the Flow of Ellipsoidal Particles in a Horizontal Rotating Drum Based on DEM Simulation

On the Influence of Inter-Particle Friction and Dilatancy in Granular Materials: a Numerical Analysis

Discrete Element Method Simulation on the Immigration of Granular Matter in a Vertically Vibrating U-Tube

A multivariate regression parametric study on DEM input parameters of free-flowing and cohesive powders with experimental data-based validation

Numerical study of dense powder flow in a rotating drum: Comparison of CFD to experimental measurements

Rolling friction measurement of slightly non-spherical particles using direct experiments and image analysis

Frictional weakening of a granular sheared layer due to viscous rolling revealed by Discrete Element Modeling

Numerical Simulation of Radial Segregation Patterns of Binary Granular Systems in A Rotating Horizontal Drum

Qualitative and quantitative analyses of particulate flows in rotating drums using a DEM-based approach