Cucurbituril and zwitterionic surfactant‐based matrix solid‐phase dispersion microextraction to simultaneously determine terpenoids from Radix Curcumae

Yan Chen,Xiao‐Ting Zhen,Ya‐Ling Yu,Min‐Zhen Shi,Jun Cao,Hui Zheng,Li‐Hong Ye
DOI: https://doi.org/10.1002/jssc.202001067
IF: 3.614
2021-01-29
Journal of Separation Science
Abstract:<p>A rapid, efficient and environmentally friendly matrix solid‐phase dispersion microextraction was established to determine and quantify terpenoids in Radix Curcumae using ultra‐high‐performance liquid chromatography with a diode array detector. Various parameters affecting the extraction were investigated in detail, such as the grinding time, amount of adsorbent, type and concentration of elution solvent, and pH. The optimization of single‐factor and response surface methodology was performed to confirm the best conditions in this procedure. The final optimized conditions were obtained by applying 70 mg of cucurbituril as adsorbent, 149 s as the optimum grinding time, and 228 mM of 3‐(N,N‐Dimethylpalmitylammonio)propanesulfonate aqueous solution (pH = 6.5) as the optimal elution solvent. The validated method showed a satisfactory linear range of 0.10‐10 μg mL<sup>−1</sup> for curdione and furanodiene, 0.01‐10 μg mL<sup>−1</sup> for isocurcumenol and germacrone, and 0.05‐10 μg mL<sup>−1</sup> for furanodienone, while the correlation coefficients ranged from 0.9945‐0.9970. The recoveries of the investigated analytes at two spiked concentration levels (0.1 and 1.0 μg mL<sup>−1</sup>) ranged from 96.53‐104.60%. In addition, this method displayed acceptable reproducibility (relative standard deviation ≤3.66%). The results showed that the newly proposed matrix solid‐phase dispersion microextraction method was successfully applied to analyze curdione, isocurcumenol, furanodienone, germacrone and furanodiene in Radix Curcumae samples.</p><p>This article is protected by copyright. All rights reserved</p>
chemistry, analytical
What problem does this paper attempt to address?