Revisit the benzene oxidation at elevated pressure

Xu-Peng Yu,Du Wang,Dong-Xu Tian,Zhen-Yu Tian
DOI: https://doi.org/10.1016/j.combustflame.2024.113469
IF: 4.4
2024-05-04
Combustion and Flame
Abstract:The benzene (A 1 ) oxidation was examined in a jet-stirred reactor (JSR) within the temperature range of 880–1010 K at 12.0 atm under both fuel lean (Φ = 0.5) and rich (Φ = 3.0) conditions. Eighteen intermediates and products were identified and quantified by gas chromatography (GC) and gas chromatograph-mass spectrometer (GC–MS). A kinetic model comprising 280 species and 1734 reactions was developed and validated against the experimental data to investigate the benzene reactions occurring at high pressure and low temperature. According to the sensitivity analysis, A 1 + OH = A 1 - + H 2 O is the most promoting reaction for fuel consumption, while A 1 OH + O 2 = A 1 O + HO 2 and A 1 OH + OH = A 1 O + H 2 O exhibited the most inhibiting effects. HO 2 radicals play an important role in the initial reaction temperature of A 1 high-pressure oxidation, where the reaction rate of A 1 OH + O 2 = A 1 O + HO 2 is particularly critical. In comparison to previous works on A 1 oxidation, oxygenated polycyclic aromatic hydrocarbons (OPAHs) benzofuran (C 8 H 6 O) and dibenzofuran (C 12 H 8 O) were newly measured and analyzed in this work. As one of the most important OPAHs species, the consumption pathway of C 8 H 6 O was updated to better describe the high-pressure oxidation. The C 8 H 6 O would potentially compete with A 1 for molecular oxygen via the pathway A 1 → A 1 O → C 8 H 6 O → decomposition products, and the process of decomposition enhances the oxygen depletion. Compared with previous oxidation studies at atmospheric pressure, the A 1 initial reaction temperature shifted from 1000 to 950 K, and the temperature window of fuel conversion sharply reduced from 300 K to 70 K. Additionally, the model was effectively applied to predict the oxidation of A 1 in a Jet-Stirred Reactor (JSR) over a wide range of pressures, from 0.46 to 12.0 atm. Furthermore, the developed model was compared with the laminar flame velocities (LBVs, ranging from 1.0 - 10.0 atm) and the ignition delay times (IDTs, ranging from 2.4 – 9.0 atm) data in the literature, and satisfactory agreement was obtained across a broad pressure range. The newly reported data and kinetic model provide helpful in further understanding the combustion mechanisms of aromatic hydrocarbon fuels.
energy & fuels,engineering, chemical, mechanical,thermodynamics, multidisciplinary
What problem does this paper attempt to address?