Abstract:Summary form only given. Capillary discharge plasmas have been widely used as electrothermal chemical (ETC) launch devices, fusion reactor pellet injectors and high heat flux sources for material studies. In the electro thermal chemical launcher, the mechanisms of the plasma-propellant interaction are critical, with many factors being of potential importance. In particular, the role of plasma radiation is disputed. We will report the effect of three different metal ions and radiation in the capillary discharge plasma on the plasma-propellant interactions. Conventionally, a capillary initiated by a metal wire of about 2 mg and with an ablative liner material (e.g. polyethylene) is used as the plasma generator. The plasma is mainly composed of CO, H + , C, etc. The proportion of metal ions was negligible. We have designed a new capillary discharge plasma generator with different metal powders of higher weight as the initiators. The performance of the new generator is compared with the traditional one through an open-air test. A spectrometer and ICCD were used to measure the surface temperature of the propellants while a CCD was used to visualize the plasma jet. The combustion tests were conducted in a transparent closed vessel, making it possible to measure the plasma parameters at the propellant surface and observe the combustion process in the closed vessel. A fused silica window was placed between the plasma and propellants to ensure that the propellant could only be affected by plasma radiation. The burning rate and the p-t curve were obtained in the tests and the combustion products were analyzed by a mass spectrometer. Interrupted burning tests were also carried out to acquire information about the surface of the propellants at different burning stages. In order to perform accurate modeling of the plasma-propellant interaction, we have also developed a two-dimensional time-dependent capillary discharge model based on a modified ablation model. In our model, special attention is paid to the radial distribution of the capillary discharge plasma characteristics. To investigate the factors that influence the radial distribution, the radial transport of the ablation products is taken into consideration. Further, the competition between the ablation and deposition process with time in the capillary discharge is also studied. The aim of our study are to provide results that will assist the design of new propellants and new plasma generators for the ETC launcher.

Experimental study of electron bombardment ion electric propulsion based on a CO 2 /Xe mixed working medium

Kinetic investigation of discharge performance for Xe, Kr, and Ar in a miniature ion thruster using a fast converging PIC-MCC-DSMC model

A study of an air-breathing electrodeless plasma thruster discharge

Iodine Electron Cyclotron Resonance Plasma Source for Electric Propulsion

Experiment and analysis of the neutralization of the electron cyclotron resonance ion thruster

Coupling plasma physics and chemistry in the PIC model of electric propulsion: Application to an air-breathing, low-power Hall thruster

Numerical and experimental research on the performance of an iodine-fed Hall thruster

Diagnostic and Modelling Investigation on the Ion Acceleration and Plasma Throttling Effects in a Dualemitter Hollow Cathode Micro-Thruster

Experimental study on the discharge of a xenon-assisted krypton Hall thruster

Experimental Research on the Neutralizer of Micro ECR Ion Thruster

Experimental Study on the Catalytic Ignition Characteristics of a Dual-Mode Ionic Liquid Propellant in Model Thrusters

Study on the Ionization and Acceleration of a Microwave Discharge Cusped Field Thruster

Argon Admixture-driven Enhanced Ionization and Performance of a 5-kW Hall Thruster on Krypton

A new configuration for high power propulsion plasmas driven by ion cyclotron resonance energization

Performance Optimization of a Krypton Hall Thruster with a Rotating Propellant Supply

Electron Cyclotron Resonance Discharge Enhancement in a Cusped Field Thruster

Sputtering of Mo and Ag with xenon ions from a radio-frequency ion thruster

Ion-induced Electron Emission Cathode for a Micro-Newton HEMP Thruster

Numerical simulation of an expanding magnetic field plasma thruster: a comparative study for argon, xenon and iodine fuel gases

Roles of Metal Ions and Plasma Radiation in the Interactions Between A Capillary Discharge Plasma and Propellants

Diagnostics of ion and electron diffusion in pulsed plasma thrusters using neutral gas injection