Abstract:We read with great interest the article by Onuma et al. [1] which evaluated the long-term safety and efficacy of ABSORB bioasorbable everolimus-eluting stent (BVS) scaffold. The investigators of the study have made pioneering contributions to the assessment of bioresorbable scaffolds. It was concluded that sustained safety could be achieved after the implantation of a fully bioresorbable Absorb everolimus-eluting scalffold with a low event rate at 5 years. Besides, the ABSORB Cohort A trial confirmed the feasibility of noninvasive anatomic and functional assessment of the scaffold with the use of multislice computed tomography (MSCT) angiography and MSCT-based fractional flow reserve (FFR) assessment. However, we have several concerns with regard to the study. First, we have to notice that noninvasive FFR analysis was feasible only in 13 patients. The limited size has weakened the reliability of noninvasive FFR performance in assessing functional outcome of ABSORB BVS. Good image quality of all coronary arteries and accurate lumen boundary descriptions are essential for the noninvasive FFR interpretation [2]. Although published reports suggested that CT derived FFR (FFRCT) accuracy was less affected by MSCT image quality than CT stenosis [3], there were four patients (22.2%) who cannot have FFRCT analysis due to severe artifact. Besides, in those with feasible FFRCT, numerous artifacts including calcification, motion, and misregistration may also affect MSCT performance and lead to inaccurate anatomic models for FFRCT computation [4]. Thus, the feasibility and precision of FFRCT need to be further improved. It is not appropriate to use FFRCT alone as a hemodynamic parameter in functional coronary stenosis measurement. Second, a fly in the ointment of the study was the absence of invasive FFR as a reference against noninvasive FFRCT at 5 years. Despite Onuma et al. demonstrated several reasons that they decided to perform repeat MSCT alone instead of invasive imaging, we cannot deny the fact that no published convincing trial exists for FFRCT in the evaluation of interventional treatment [4], although the DISCOVER-FLOW study [5] validated that the FFRCT had a good correlation with an invasive FFR, and the DeFACTO trial [6] demonstrated that the FFRCT plus CT was superior to CT alone as a measure of coronary computed tomography angiography (CCTA) stenosis severity for determination of lesion-specific ischemia. Finally, in the study, angiographic reference standard of the vessel lumen area was derived from MSCT analysis instead of invasive coronary angiography [1]. It is important, however, to note that there is an overestimation of stenosis severity identified by CCTA and even among severe stenosis confirmed by invasive coronary angiography, only a minority cause ischemia [4,6]. Therefore, the possible deviation resulted from the inaccurate reference of MSCT may make the results less convincible.

An experimental assessment of catheter trackability forces with tortuosity parameters along patient-specific coronary phantoms

The Effects That Cardiac Motion has on Coronary Hemodynamics and Catheter Trackability Forces for the Treatment of Coronary Artery Disease: An In Vitro Assessment

Development of a patient-specific model of the human coronary system for percutaneous transluminal coronary angioplasty balloon catheter training and testing

Numerical Methodology to Evaluate Trackability and Pushability of PTCA Balloon Catheter

Computational replication of the patient-specific stenting procedure for coronary artery bifurcations: From OCT and CT imaging to structural and hemodynamics analyses

Computational Investigation of Vessel Injury Due to Catheter Tracking During Transcatheter Aortic Valve Replacement

Computed Tomography-based Patient-specific Biomechanical and Fluid Dynamic Study of Anomalous Coronary Arteries with Origin from the Opposite Sinus and Intramural Course.

Optimal Site for Proximal Optimization Technique in Complex Coronary Bifurcation Stenting: A Computational Fluid Dynamics Study.

Challenges in Multislice Computed Tomography Based Fractional Flow Reserve to Evaluate Interventional Treatment

Rheolytic Effects of Left Main Mid-Shaft/distal Stenting: a Computational Flow Dynamic Analysis

Path tracking control of a steerable catheter in transcatheter cardiology interventions

Assessment of distal access catheter performance during neuroendovascular procedures: measuring force in three-dimensional patient specific phantoms

Non-invasive Evaluation of Fluid Dynamic of Aortoiliac Atherosclerotic Disease: Impact of Bifurcation Angle and Different Stent Configurations

Coronary Obstruction Analysis in Transcatheter Aortic Valve Implantation Through Patient-Specific Computational Modelling

Experimental Study on Anastomotic Hemodynamics Using Tomographic Particle Image Velocimetry

An in-vitro method for comparative analysis of aspiration catheter tracking performance

A novel angiography-based computational modelling for assessing the dynamic stress and quantitative fatigue fracture risk of the coronary stents immediately after implantation: Effects of stent materials, designs and target vessel motions

Three dimensional reconstruction of coronary artery stents from optical coherence tomography: experimental validation and clinical feasibility

Mild Anastomotic Stenosis in Patient-Specific CABG Model May Enhance Graft Patency: A New Hypothesis

Patient-Specific 3D Volumetric Reconstruction of Bioresorbable Stents: A Method to Generate 3D Geometries for Computational Analysis of Coronaries Treated with Bioresorbable Stents

Finite element analysis for mechanics of guiding catheters in transfemoral intervention