In-situ graphene modified self-supported boron-doped diamond electrode for Pb(II) electrochemical detection in seawater

Jingxuan Pei,Xiang Yu,Zhiqiang Zhang,Jing Zhang,Songbo Wei,Rabah Boukherroub
DOI: https://doi.org/10.1016/j.apsusc.2020.146761
IF: 6.7
2020-10-01
Applied Surface Science
Abstract:<p>This work focuses on improving the repeatability and lifetime of a sensor for the electrochemical detection of trace Pb<sup>2+</sup> in seawater. An <em>in-situ</em> graphene modification method was proposed to prepare graphene functionalized self-supported boron-doped diamond (G/SBDD) electrode. A pre-coated copper film on SBDD catalyzed graphene growth through vacuum-annealing at the temperature of 1000 °C. The formation of <em>in-situ</em> graphene was systemically investigated, and a homogeneous bilayer graphene with low defect was <em>in-situ</em> grown on SBDD. Then, the electrochemical behavior of SBDD and G/SBDD for Pb<sup>2+</sup> was evaluated in simulated seawater. Compared to SBDD, G/SBDD exhibited a larger active surface area of 0.27 cm<sup>2</sup>, a higher response signal, and a smaller charge transfer resistance (R<sub>ct</sub>) of 312 Ω cm<sup>−2</sup>. Under optimized experimental conditions (a deposition potential of −0.6 V and an accumulation time of 125 s), the G/SBDD electrode achieved a sensitivity of 0.475 μA L μg<sup>−1</sup> cm<sup>−2</sup> and a detection limit of 0.21 μg L<sup>−1</sup> over a wide linear range of 1–100 ppb. Also, the electrode exhibited good reproducibility (RSD value of 2.7%), enhanced stability (96% of the initial response signal after 60 days) and high selectivity. The performance of the designed electrode holds promise for monitoring Pb<sup>2+</sup> in seawater.</p>
chemistry, physical,physics, applied, condensed matter,materials science, coatings & films
What problem does this paper attempt to address?