Abstract:The geosynthetic-encased vertical column and geosynthetic-embedded horizontal cushion are recognized as the effective methods to reduce the settlement of the soft subgrade. This paper investigated the settlement behavior of a soft subgrade reinforced by geogrid-encased stone column and geocell-embedded sand cushion using the finite element analysis method (Plaxis 2D). The simulating settlement was in good agreement with the field monitoring data, indicating the reasonability of the designed model and adopted parameters. After that, the factors, geocell layer in sand cushion, encasement length around stone column, and standing time between embankment filling stages, were employed to study their influences on the subgrade settlement. The results showed that the embedment of geocell reduced construction settlement, postconstruction settlement, and differential settlement is attributed to the increase in stiffness of sand cushion and therefore the uniform distribution of additional stress on subgrade surface. When the encasement length of stone column increased from 1D (one time the column diameter) to 8D (full encasement), the settlement in construction stage and postconstruction stage decreased by 32.2% and 35.1%, respectively, which is benefited from the increase in the compression modulus of the column. The maximum lateral deformation occurred at the position of about 2D from the top of the stone column, and it decreased more significantly when the encasement length increased from 1D to 4D than that from 4D to 8D. The encasement length up to 4D is found to be adequate in reducing the subgrade settlement and the column lateral deformation based on the consideration of performance and economy. The extension of the filling interval increased the construction settlement caused by soil consolidation, while it decreased the postconstruction settlement.

Evaluating the Geoengineering Performance of a Gravity Multiblock Quay Wall and Jet-Grouting on Marine Clayey Soils along the Korean Coastline

Effect of Groundwater Fluctuations on Pore Pressures and Earth Pressures on Coastal Excavation Retaining Walls

Field Studies of Dynamic Compaction on Marine Deposits

Centrifugal Model Test and Numerical Analysis of Deformation and Stability of Seawall on Soft Clay

Settlement Behavior of Soft Subgrade Reinforced by Geogrid-Encased Stone Column and Geocell-Embedded Sand Cushion: A Numerical Analysis

Field Tests of the Lateral Monotonic and Cyclic Performance of Jet-Grouting-Reinforced Cast-In-Place Piles

Performance of a deep excavation and the influence on adjacent piles: A case history in karst region covered by clay and sand

A review of jet grouting practice and development

Economic Sediment Transport Control with Sediment Flushing Curves for Sea Dike Gate Operation: Case Study in Saemangeum Basin, Korea

Excess pore water pressure caused by the installation of jet grouting columns in clay

Fluid-soil interaction analysis for jet grouting in sands based on numerical simulation

Field-test investigation on influence of soft soil by continuous jet grouting

Laboratory Experimental Study on GESC Combined with Electroosmosis for Ground Improvement

Critical application zone of the jet grouting piles in the vicinity of existing high-speed railway bridge in deep soft soils with medium sensibility

Stability of jetties for channel protection in soft soils at Huanghua Port

Study on the Construction Method and Effects of Ipsilateral, Multi-Nozzle, High-Pressure Jet Grouting Cut-Off Wall

Non-Dispersive Anti-Washout Grout Design Based on Geotechnical Experimentation for Application in Subsidence-Prone Underwater Karstic Formations

Seismic Performance of Block-Type Quay Walls with Liquefiable Calcareous Sand Backfill

Functional Assessment of Coastal Buffer Zone Installation Using In-Situ Measurements from Sinji-Myongsasimni Beach

Evaluation of beach response due to construction of submerged detached breakwater

Numerical-geostatistical-based approach to investigate the earth pressure evolution within the large grid wall foundation under adjacent surcharge loading