Abstract:Common analytical assessment methods for concrete dams are unlikely to predict material fracture in the dam body because of the assumption of rigid body behavior and uniform- or linear stress distribution along a predetermined failure surface. Hence, probabilistic non-linear finite element analysis, calibrated from scale model tests, was implemented in this study to investigate the impact of concrete material parameters (modulus of elasticity, tensile strength, compressive strength, fracture energy) on the ultimate capacity of scaled model dams. The investigated dam section has two types of large asperities, located near the downstream and/or upstream end of the rock–concrete interface. These large-scale asperities significantly increased the interface roughness. Post-processing of the numerical simulations showed interlocking between the buttress and the downstream asperity leading to fracture of the buttress with the capacity being determined mainly by the tensile strength of the buttress material. The capacity of a model with an asperity near the upstream side, with lower inclination, was less dependent on the material parameters of the buttress as failure occurred by sliding along the interface, even with inferior material parameters. Results of this study show that material parameters of the concrete in a dam body can govern the load capacity of the dam granted that significant geometrical variations in the rock–concrete interface exists. The material parameters of the dam body and their impact on the capacity with respect to the failure mechanism that developed for some of the studied models are not commonly considered to be decisive for the load capacity. Also, no analytical assessment method for this type of failure exists. This implies that common assessment methods may misjudge the capacity and important parameters for certain failure types that may develop in dams.

Hydraulic fracturing simulation of concrete dam integrating intelligent crack detection and refined modeling methods

A Dynamic FEM-DEM Multiscale Modeling Approach for Concrete Structures

Analysis of Hydraulic Fracturing in Concrete Dam Considering Fluid–structure Interaction Using XFEM-FVM Model

Two-Dimensional Meso-Scale Simulation of Hydraulic Fracture in Concrete

Data-driven crack behavior anomaly identification method for concrete dams in long-term service using offline and online change point detection

New graphic method for quantitatively analyzing characteristic parameters of concrete cracks

A Mesoscale Modelling Approach Coupling SBFEM, Continuous Damage Phase-Field Model and Discrete Cohesive Crack Model for Concrete Fracture

Evaluating the Safety of High Arch Dams with Fractures Based on Numerical Simulation and Geomechanical Model Testing

Numerical simulation on dam cracking analysis using DFPA code

Multi-sensing investigation of crack problems for concrete dams based on detection and monitoring data: A case study

Horizontal Cracking and Crack Repair Analysis of a Super High Arch Dam Based on Fracture Toughness

Comprehensive investigation of leakage problems for concrete gravity dams with penetrating cracks based on detection and monitoring data: A case study

Probabilistic finite element analysis of failures in concrete dams with large asperities in the rock–concrete interface

Numerical Simulation of the Process of Hydraulic Fracturing in Earth and Rockfill Dams

A poromechanical‐damage‐based‐model for water‐driven fracture modeling of concrete gravity dams

Modelling of Crack Propagation of Gravity Dams by Scaled Boundary Polygons and Cohesive Crack Model

Research on the Crack Stability of Dam Concrete Based on the Measured Monitoring Data

A Primary Digital Dam Simulation System for an Arch Dam

Chemo-damage Modeling and Cracking Analysis of AAR-affected Concrete Dams

Wavelet-fractal diagnosis model and its criterion for concrete dam crack status

Experimental and Numerical Study of Cracking Behavior of Openings in Concrete Dams