Abstract:For a dynamic system of a rotating flexible cantilever beam, the traditional model assumes the small deformation in structural dynamics where axial and transverse displacements at any point in the beam are uncoupled. This traditional hybrid coordinate model is referred as the zero-order approximation coupling model in this paper, which may result in divergence to the dynamic problem of a flexible cantilever beam with a high rotational speed. In this paper, a first-order approximation coupling model is presented to analyze the dynamics of rotating flexible beam system, which is based on the Hamilton theory and the finite element discretization method. The proposed model for the system considers the second-order coupling quantity of the axial displacement caused by the transverse displacement of the beam. The dynamic characteristics of the rotating beam system when using the zero-order approximation coupling model are compared with those when using the first-order approximation coupling models through numerical simulations. In addition, the applicability of the two dynamic models for control design are studied by using the classical optimal control method. Simulation and comparison studies show that, for the case without control for the system, there exists big difference between the result using the zero-order approximation coupling model and that using the first-order approximation coupling model even for the case of small angular velocity of the system. The larger is the angular velocity, the bigger is the difference. Vibration frequency of the beam by using the first-order approximation coupling model is higher than that by using the zero-order approximation coupling model. When the angular velocity of the system is close to or is larger than the fundamental frequency of the beam without rotation motion, the zero-order approximation coupling results in a wrong result, while the first-order approximation coupling model is valid. For the case with control for the system, the applicability of the zero-order approximation coupling model can be much broadened. The critical angular velocity of the system for validity of the zero-order approximation coupling model is much larger than that without control for the system. The first-order approximation coupling model is available not only for the case of small angular velocity but also for the case of large angular velocity of the system, and is applicable to the cases with or without control for the system.

Dynamic and stability analysis of a cantilever beam system excited by a non-ideal induction motor

Comparison of three composite induction motor load models

Modeling and Simulation of Non-Linear Dynamic Process of the Induction Motor System with Fluctuating Potential Loads

Attenuation of Sommerfeld effect in a four DOF vibration system driven by a non-ideal induction motor

Dynamic modeling and vibration response analysis of high speed motorized spindle

Parametrically Excited Stability of Periodically Supported Beams under Longitudinal Harmonic Excitations

Stochastic Vibration Suppression Analysis of an Optimal Bounded Controlled Sandwich Beam with MR Visco-Elastomer Core

Stability and damping performance analysis of induction motor

Transient analysis of multi-field coupling on suspension inertial vibration machine

Dynamics modeling and electromechanical coupling characteristics analysis of cage induction motors

On the non-linear dynamic behavior of a rotor–bearing system

Coupled Electromagnetic-Dynamic Modeling and Bearing Fault Characteristics of Induction Motors considering Unbalanced Magnetic Pull

Model study and active control of a rotating flexible cantilever beam

Experimental investigation and theoretical modelling on nonlinear dynamics of cantilevered microbeams

Dynamics Analysis of the Nonlinear Rotor System with Geislinger Coupling

Integrated Modeling and Analysis of Ball Screw Feed System and Milling Process with Consideration of Multi-Excitation Effect

Vibration Analysis of an Induction Motor

Analysis for the Vibration Characteristics of the Induction Machine in Different Operating Status

STATIC VOLTAGE STABILITY ANALYSIS CONSIDERING INDUCTION MOTOR LOADS

Stability Analysis and Mitigation of Oscillation in an Induction Machine

DYNAMIC ANALYSIS ON VIBRO-IMPACT BETWEEN TWO CANTILEVERS EXCITED BY HARMONIC FORCE