Abstract:Background: Extremities fractures are a leading cause of death and disability, especially in the elderly. Avulsion fracture are also the most commonly missed diagnosis, and delayed diagnosis leads to higher litigation rates. Therefore, this study evaluates the diagnostic efficiency of the artificial intelligence (AI) model before and after optimization based on computed tomography (CT) images and then compares it with that of radiologists, especially for avulsion fractures.Methods: The digital X-ray photography [digital radiography (DR)] and CT images of adult limb trauma in our hospital from 2017 to 2020 were retrospectively collected, with or without 1 or more fractures of the shoulder, elbow, wrist, hand, hip, knee, ankle, and foot. Labeling of the fracture referred to the visualization of the fracture on the corresponding CT images. After training the pre-optimized AI model, the diagnostic performance of the pre-optimized AI, optimized AI model, and the initial radiological reports were evaluated. For the lesion level, the detection rate of avulsion and non-avulsion fractures was analyzed, whereas for the case level, the accuracy, sensitivity, and specificity were compared among them.Results: The total datasets (1,035 cases) were divided into a training set (n=675), a validation set (n=169), and a test set (n=191) in a balanced joint distribution. At the lesion level, the detection rates of avulsion fracture (57.89% vs. 35.09%, P=0.004) and non-avulsion fracture (85.64% vs. 71.29%, P<0.001) by the optimized AI were significantly higher than that by pre-optimized AI. The average precision (AP) of the optimized AI model for all lesions was higher than that of pre-optimized AI model (0.582 vs. 0.425). The detection rate of avulsion fracture by the optimized AI model was significantly higher than that by radiologists (57.89% vs. 29.82%, P=0.002). For the non-avulsion fracture, there was no significant difference of detection rate between the optimized AI model and radiologists (P=0.853). At the case level, the accuracy (86.40% vs. 71.93%, P<0.001) and sensitivity (87.29% vs. 73.48%, P<0.001) of the optimized AI were significantly higher than those of the pre-optimized AI model. There was no statistical difference in accuracy, sensitivity, and specificity between the optimized AI model and the radiologists (P>0.05).Conclusions: The optimized AI model improves the diagnostic efficacy in detecting extremity fractures on radiographs, and the optimized AI model is significantly better than radiologists in detecting avulsion fractures, which may be helpful in the clinical practice of orthopedic emergency.

Can computer vision / artificial intelligence locate key reference points and make clinically relevant measurements on axillary radiographs?

[Progress on Artificial Intelligence Assisted X-ray Film Recognition in Orthopedics].

Development of a diagnostic support system for distal humerus fracture using artificial intelligence

Computer-Aided Assessment of Catheters and Tubes on Radiographs: How Good is Artificial Intelligence for Assessment?

Automatic quantification of scapular and glenoid morphology from CT scans using deep learning

Artificial intelligence to detect the femoral intertrochanteric fracture: The arrival of the intelligent-medicine era

Artificial intelligence can be used in the identification and classification of shoulder osteoarthritis and avascular necrosis on plain radiographs: a training study of 7,139 radiograph sets

Comparison between artificial intelligence solution and radiologist for the detection of pelvic, hip and extremity fractures on radiographs in adult using CT as standard of reference

Application of Deep-Learning–based Artificial Intelligence in Acetabular Index Measurement

APPLICATION OF ARTIFICIAL INTELLIGENCE TO ASSIST HIP FRACTURE DIAGNOSIS USING PLAIN RADIOGRAPHS

The Development of a Yolov8-Based Model for the Measurement of Critical Shoulder Angle (CSA), Lateral Acromion Angle (LAA), and Acromion Index (AI) from Shoulder X-ray Images

Fully Automated Measurement of Cobb Angles in Coronal Plane Spine Radiographs

Diagnostic accuracy and potential covariates of artificial intelligence for diagnosing orthopedic fractures: a systematic literature review and meta-analysis

Automatic AI tool for opportunistic screening of vertebral compression fractures on chest frontal radiographs: A multicenter study

Artificial intelligence versus radiologist in the accuracy of fracture detection based on computed tomography images: a multi-dimensional, multi-region analysis

AI-based X-ray fracture analysis of the distal radius: accuracy between representative classification, detection and segmentation deep learning models for clinical practice

Clinical Validation of a Deep Learning-Based Software for Lumbar Bone Mineral Density and T-Score Prediction from Chest X-ray Images

Quality control of elbow joint radiography using a YOLOv8-based artificial intelligence technology

Artificial Intelligence X-ray Measurement Technology of Anatomical Parameters Related to Lumbosacral Stability.

Artificial Intelligence-Based Surgery Support Model Using Intraoperative Radiographs for Assessing the Acetabular Component Angle

The ensemble artificial intelligence (AI) method: Detection of hip fractures in AP pelvis plain radiographs by majority voting using a multi-center dataset