Abstract:Photocatalytic hydrogen generation by solar energy is a promising approach to clean energy resource and has attracted great attention over the past decades. [1] Perovskites ABO3 structures provide the basic stable framework to both crystal and electronic structures modification, which have found extensive applications in photocatalysis, solar cells and photoelectrochemical (PEC) water splitting. [2] LaFeO3 has a suitable band gap of 2.07eV [3, 4] and exhibits excellent visible light photocatalytic performance. However, the poor charge transport and slow reaction kinetics at the surface [3, 4] are the main factors limiting its further improvement on photocatalytic application. To overcome these obstacles, transition metals (Mn, Co, Cu) are introduced into LaFeO3 and the photocurrent of 10% Cu doped sample is improved by three times than that of LaFeO3. The reduced charge transport resistance owing to the Fe3+ discharge is identified to benefit the PEC performance improvement after TM doping. On the other hand, the surface state of LaFeO3 is modified by electrodepositing of amorphous cobalt-phosphate (Co-Pi). It shows that the presence of Co-Pi down-shifts the onset potential by ~ 560 mV for anodic photocurrent and the improvement can be attributed to the enhanced water oxidation due to the CoII/CoIII-OH discharge on Co-Pi decorated layers. The transition anodic photocurrent is improved by about six times after Co-Pi coating under visible light at 0.50 V vs. Ag/AgCl and the electrochemical impedance spectroscopy certifies the enhanced charge transfer, which contributes to the meliorative anodic photocurrent. The incident photon-to-current conversion efficiencies of LaFeO3 can be promoted from 1.37% to 2.14% at 400 nm after Co-Pi coating. Our results demonstrate that modification of the electronic structure (TM doping) and surface state (Co-Pi coating) are the promising way to promote the photoconversion efficiency of LaFeO3-based PEC cells under visible light. References: X. Lu, S. Xie, H. Yang, Y. Tong, H. Ji, Chem. Soc. Rev., 43, 7581 (2014). Z. G. Yi and J. Ye, Appl. Phys. Lett., 91, 254108 (2007). K. M. Parida, K. H. Reddy, S. Martha, D. P. Das and N. Biswal, Int. J. Hydrogen Energy, 35, 12161 (2010). Q. Peng, B. Shan, Y. Wen and R. Chen, Int. J. Hydrogen Energy, 40, 15423 (2015).

Interfacial electric field optimization and co-catalyst free LaFeO3-based p-p-type homojunction for efficient PEC water splitting

Quasi-polymeric construction of stable perovskite-type LaFeO3/g-C3N4 heterostructured photocatalyst for improved Z-scheme photocatalytic activity via solid p-n heterojunction interfacial effect.

Hierarchical NiCo2S4@NiFe LDH Heterostructures Supported on Nickel Foam for Enhanced Overall-Water-Splitting Activity

Synthesis of a Cu2O/Carbon Film/NiCoB‐Grpahene Oxide Heterostructure As Photocathode for Photoelectrochemical Water Splitting

Enhanced Photoelectrochemical Water Oxidation by Fabrication of p-LaFeO3/n-Fe2O3 Heterojunction on Hematite Nanorods

Constructing FeCoNi-LDH/MOF heterostructure as cocatalyst on hematite photoanode for highly efficiency water splitting

An Interface‐cascading Silicon Photoanode with Strengthened Built‐in Electric Field and Enriched Surface Oxygen Vacancies for Efficient Photoelectrochemical Water Splitting

Modulating Interfacial Charge Transfer Behavior through the Construction of a Hetero-Interface for Efficient Photoelectrochemical Water Splitting

MoS 2 modified NiFe LDH hierarchical structure as efficient photoanode towards photoelectrochemical water splitting

Green electrodeposition synthesis of NiFe-LDH/MoOx/BiVO4 for efficient photoelectrochemical water splitting

Band-Engineered LaFeO$_{3}$-LaNiO$_{3}$ Thin Film Interfaces for Electrocatalysis of Water

WO 3 /FeOOH heterojunction for improved charge carrier separation and efficient photoelectrochemical water splitting

Modification of the Electronic Structure and Surface State of LaFeO3 for Improved Visible Light Photoelectrochemical Water Oxidation

Modulating built-in electric field via Bi-VO4-Fe interfacial bridges to enhance charge separation for efficient photoelectrochemical water splitting

High-efficient and durable overall water splitting performance by interfacial engineering of Fe-doped urchin-like Ni2P/Ni3S2 heterostructure

Surface engineering of superhydrophilic Ni2P@NiFe LDH heterostructure toward efficient water splitting electrocatalysis

WO3@α‐Fe2O3 Heterojunction Arrays with Improved Photoelectrochemical Behavior for Neutral Ph Water Splitting

Design and In Situ Growth of Cu 2 O‐Blended Heterojunction Directed by Energy‐Band Engineering: Toward High Photoelectrochemical Performance

Interfacial engineering induced highly efficient CoNiP@NiFe layered double hydroxides bifunctional electrocatalyst for water splitting

Facile one-step synthesis of a WO 3 /ZnWO 4 heterojunction modified using ZnFe LDH enhances the PEC water splitting efficiency

Integration of a Cu2O/ZnO heterojunction and Ag@SiO2 into a photoanode for enhanced solar water oxidation