Abstract:Due to the inherent time delay in dust concentration data transmission, dust reduction equipment is unable to respond according to the current moment's dust concentration. Hence, the focus of mine dust concentration detection technology extends beyond the current dust concentration to accurately predicting the next moment's dust concentration, allowing a response window for dust reduction equipment, leading to more optimal dust reduction effects. This necessitates the introduction of the Kalman filtering algorithm. Despite the traditional single Kalman filtering algorithm's ability to make certain dust concentration predictions, it is constrained by high-temperature, high-humidity underground environments and electromagnetic pulse signal interference from fan and coal mining machine operations, with an error rate reaching up to 40%, seriously disrupting underground dust reduction equipment. However, the composite Kalman filtering algorithm incorporating the 3σ rule effectively eliminates bad values and removes instability from the underground environment and noise, rendering it applicable to most complex environments, providing accurate predicted concentrations for dust reduction equipment, and boosting overall universality. This study designed a fusion algorithm based on the Pauta criterion and Kalman filter to further optimize the dust concentration detection technology based on electrostatic induction. The sensor's model and measuring principle were first analyzed, and the initial calibration and precision testing of the sensor using the experimental system were completed. The dust concentration fluctuation characteristics were then modeled with Matlab, and the noise variance was estimated to process and filter the dust concentration data with the Pauta criterion, Kalman filter, and fusion algorithm respectively. The accuracy of the dust concentration sensor was tested again after applying the fusion algorithm, which proved to significantly enhance the stability and accuracy of the electrostatic induction-based dust concentration sensor. This study has critical implications for coal mine dust concentration monitoring and coal miner occupational health protection.

Machine Learning-Based Precise Monitoring of Aluminium-Magnesium Alloy Dust

A Blast Furnace Fault Monitoring Algorithm with Low False Alarm Rate:Ensemble of Greedy Dynamic Principal Component Analysis-Gaussian Mixture Model

Improvement and optimization of coal dust concentration detection technology: Based on the 3σ criterion and the Kalman filtering composite algorithm

A novel method for fast identification of a machine tool selected point temperature rise based on an adaptive unscented Kalman filter

A Self-Training-based Approach for Aluminum Alloy Casting Quality Prediction

Material level detection of blast furnace based on the fusion of membership degree classification and sliding window Model

An Improved Machine Learning Approach for Optimizing Dust Concentration Estimation in Open-Pit Mines

Machine learning-assisted fluorescence visualization for sequential quantitative detection of aluminum and fluoride ions

Research on Online Monitoring Technology and Filtration Process of Inclusions in Aluminum Melt

Cross-concentration calibration of low-cost sensors for effective dust monitoring at construction sites

Assessing occupational hazards in welding operations: A machine learning-based approach for worker safety in Indian foundries

CFD Modeling of Ventilation and Dust Flow Behavior in Polishing and the Design of an Innovative Wet Dust Removal System

Hybrid machine learning approach integrating GMDH and SVR for heavy metal concentration prediction in dust samples

Accurate long-term dust concentration prediction in open-pit mines: A novel machine learning approach integrating meteorological conditions and mine production intensity

Oil metal abrasive swarf detection system based on Kalman filtering

Prediction of heavy metals in airborne fine particulate matter using magnetic parameters by machine learning from a metropolitan city in China

Research on On-Line Monitoring of Grinding Wheel Wear Based on Multi-Sensor Fusion

Application of artificial intelligence algorithms and low-cost sensors to estimate respirable dust in the workplace

Acoustic Signal-Based Tool Condition Monitoring in Belt Grinding of Nickel-Based Superalloys Using RF Classifier and MLR Algorithm

An interpretable machine learning approach for ferroalloys consumptions

Machine learning approach for screening alloy surfaces for stability in catalytic reaction conditions