Abstract:SBS/waste tire rubber powder compound‐ or single‐doped waste tire rubber powder‐modified asphalt mixture had better frost resistance. The unified calculation model for strength deterioration obtained by using a single logarithmic coordinate transformation could reflect the strength and deterioration rate through material parameters. The study focused on preparing modified asphalt and its mixtures using waste tire rubber powder and polystyrene–butadiene–styrene (SBS). The modified asphalt was divided into two types: single‐doped waste tire rubber powder and SBS/waste tire rubber powder, and modified asphalt mixtures were prepared by dry or wet processes. Based on the temperature and freeze–thaw characteristics of seasonal freezing areas, the mechanical evolution for waste tire rubber powder‐modified asphalt and its mixture was analyzed. The results showed the following. (1) The waste tire rubber powder‐modified asphalt viscosity was closely related to the amount and particle size of rubber powder. A particle size of 60 mesh or 80 mesh and an amount between 18% and 25% were suitable. (2) Combined with dynamic mechanical analysis and needle penetration test, the single‐doped waste tire rubber powder‐modified asphalt with 80 mesh rubber powder particles and 18–25% rubber powder content was suitable. The SBS/waste tire rubber powder compound‐modified asphalt (SBS 3%; rubber powder 16%, particle size 80 mesh; aromatic oil 4%; stabilizer 3‰) had better high‐ and low‐temperature performance improvement. (3) The splitting tensile strength of modified asphalt mixture deteriorated rapidly during the first 10 freeze–thaw cycles, and then tended to stabilize. The SBS/waste tire rubber powder compound‐ or single‐doped waste tire rubber powder‐modified asphalt mixture had better frost resistance. (4) The unified calculation model for strength deterioration obtained by using a single logarithmic coordinate transformation could reflect the strength and deterioration rate through the material parameters. (5) At high or low temperatures, the modified asphalt mixture presented flexible or brittle failure, respectively, with a critical brittle failure temperature near −10 °C. While, the dry process modified asphalt mixture was not suitable for service in seasonal freezing regions. The study was used to further understand the mechanical characteristics of waste tire rubber powder‐modified asphalt and its mixture under environmental load in seasonal freezing regions. © 2024 Society of Chemical Industry.

Experimental study on the mechanical evolution for waste tire rubber powder‐modified asphalt and its mixture considering the temperature characteristics in seasonal freezing regions

Mechanical Performance Of Warm-Mixed Porous Asphalt Mixture With Steel Slag And Crumb-Rubber-Sbs Modified Bitumen For Seasonal Frozen Regions

Experimental Study on the Performance Decay of Permeable Asphalt Mixture in Seasonally Frozen Regions under Freeze-Thaw Cycles

High- and Low-Temperature Fracture Behavior of Pervious Asphalt Mixtures under Different Freeze–thaw Cycles Based on Acoustic Emission Technique

Comparative Analysis of Rheological and Microscopic Performance of SBS Modified Asphalt Based on Field Aging and Laboratory Aging

Research of Method for Improving Antifreeze-Thaw Performance Based on Asphalt Mixture Freeze-Thaw Damage Development Process

Multilevel Analysis of the Aging Mechanisms and Performance Evolution of Rubber-Modified Asphalt

Low-Temperature Crack Resistance of High-Content Rubber-Powder-Modified Asphalt Mixture under Freeze–Thaw Cycles

Research on low temperature rheological behavior of aging resistant bitumen and mixture

Research on fatigue performance of composite crumb rubber modified asphalt mixture under freeze thaw cycles

Research on Preparation and High Temperature Behavior of High-Modulus Asphalt

Low-Temperature Performance and Damage Constitutive Model of Eco-Friendly Basalt Fiber–Diatomite-Modified Asphalt Mixture under Freeze–Thaw Cycles

Investigation of the Microcharacteristics of Asphalt Mastics under Dry–Wet and Freeze–Thaw Cycles in a Coastal Salt Environment

Research on the Rheological Performance of Fast-Melting SBS-Modified Asphalt under Complex Environmental Factors

Weathering characteristics of asphalt modified by hybrid of micro-nano tire rubber and SBS

Rheological Properties and Performance Evaluation of Different Types of Composite-Modified Asphalt in Cold Regions

Establishment of Complex Modulus Master Curves Based on Generalized Sigmoidal Model for Freeze–Thaw Resistance Evaluation of Basalt Fiber-Modified Asphalt Mixtures

A comprehensive study on the rheological properties of desulfurized rubberized asphalt and establishment of micro-scale mechanical models

Characterization of Phase Structure and Performance Degradation of Aged SBS-Modified Asphalt

Experimental Investigation on the Performance of SBS-Modified Asphalt Waterproofing Membrane by Thermo-Oxidative Aging and Freeze–Thaw Cycle

Low Temperature and Fatigue Characteristics of Treated Crumb Rubber Modified Asphalt after a Long Term Aging Procedure