Abstract:Pyrolysis shows potential as a resource treatment technology for municipal solid waste (MSW). In this paper, pyrolysis and combustion characteristics of typical MSW in constant temperature were investigated by reacting in a fixed bed electric heating furnace. First, the pyrolysis gas compositions of typical waste fractions such as paper, fabrics, kitchen rubbish, branches, plastics and rubber were investigated as a function of time at 750 °C. The results show that for different MSW components, reaching the peak of pyrolysis gas content spends a different time. The H 2 content increases with the increase of pyrolysis time, which indicates that the dehydrogenation reaction is more intense at the high-temperature stage, and a certain amount of hydrogen is precipitated when the large molecules are decomposed into small molecules. However, as a polymer compound, the H 2 content of rubber increases at the beginning of pyrolysis, but with the increase of time, the H 2 content begins to fluctuate and there is no obvious pattern. Secondly, the MSW was combined into by these typical components according to a certain proportion, and then the relationship of flue gas with temperature and excess air coefficient was studied using this MSW as fuel. The results show that NOx content of flue gas with the increased temperature, the increase amplitude is bigger, while with the increase of excess air coefficient, the increased amplitude is smaller. The SO 2 content of flue gas has a positive correlation with temperature and a negative correlation with excess air coefficient. This indicates that the use of lower temperatures and higher excess air coefficients can help to reduce pollutant gas emissions.

Design and operation of a fixed-bed pyrolysis-gasification-combustion pilot plant for rural solid waste disposal

Pyrolysis of Plastics-Free Refuse Derived Fuel Derived from Municipal Solid Waste and Combustion of the Char Products in Lab and Pilot Scales: A Comparative Study

Analysis on low-temperature polyethylene pyrolysis and gasification in different atmospheres

Pyrolysis-combustion of rural solid waste: Self-sustaining operation and pollutants emission

Co-gasification of rural solid waste and biomass in rural areas: Simulation and plant-scale process

Co-gasification of Acid Hydrolysis Residues and Sewage Sludge in a Downdraft Fixed Gasifier with CaO As an In-Bed Additive

Effect of Operating Parameters and Moisture Content on Municipal Solid Waste Pyrolysis and Gasification

Study on the pyrolysis and combustion characteristics of municipal solid waste in a fixed bed

Analysis of the Pyrolysis of Solid Recovered Fuel and Its Sorted Components by using TG-FTIR and DAEM

Study on Pyrolysis and Gasification of Wood in MSW

Pyrolysis and Subsequent Direct Combustion of Pyrolytic Gases for Sewage Sludge Treatment in China

Development of pilot-plant for the step pyrolysis of waste tires and analysis of product characteristics

Insight into the gas pollutants emission of rural solid waste during the gasification-combustion process: Influencing factors and mechanisms

TGA Pyrolysis and Gasification of Combustible Municipal Solid Waste

Interactive Effect of the Sorted Components of Solid Recovered Fuel Manufactured from Municipal Solid Waste by Thermogravimetric and Kinetic Analysis.

An innovative combined on-site process for the remote rural solid waste treatment--a pilot scale case study in China.

Pyrolysis Experiment of Refuse Derived Fuel and Study on Characteristics of Semi-Coke

[Utilization strategies of Chinese medicinal solid waste by pyrolysis and gasification technology].

Pilot test of heat transfer in solid waste control oxygen

Characteristics of the pyrolytic products and the pollutant emissions at different operating stages from a pilot waste tire pyrolysis furnace

Pilot-scale Pyrolysis Experiment of Municipal Sludge and Operational Effectiveness Evaluation