Abstract:Biomass calcium looping gasification (CLG) for CO 2 capture and H 2 production is rather attractive but still needs developing low-cost CaO-based sorbent with enhanced mechanical strength, cyclic CO 2 absorption reactivity, and multi-cycle gasification performance. In this work, cement-modified carbide slag was developed as a type of cheap CaO sorbent which was prepared by an economical method of wet mixing. Characterization of modified carbide slag revealed that mayenite (Ca 12 Al 14 O 33 ) was successfully synthesized which played important role in promoting sintering resistance and mechanical strength of carbide slag sorbent. Cyclic CO 2 capture tests with a thermogravimetric analyzer (TGA) verified that cement-modified carbide slag showed much higher CO 2 absorption capacity than natural carbide slag. Modified carbide slag with 15 wt% cement (CS15) presented the best CO 2 capture performance in this work, and the CaO conversion approached 58.3% after 15 cycles. Biomass calcium looping gasification tests for H 2 production were also conducted in a fluidized bed reactor under different conditions, with special attention to the cyclic gasification performance of CS15. Gasification results proved that adding carbide slag not only apparently increased H 2 concentration and H 2 yield but also reduce the yield of tar species. Cement-modified carbide slag showed better gasification performance than natural carbide slag. Although increasing gasification temperature was beneficial to promote biomass conversion and H 2 yield, too high temperature should be avoided which would inhibit water gas shift reaction, CO 2 capture, and result in the conversion of tar species to polycyclic aromatic hydrocarbons (PAHs). Moreover, results of cyclic gasification tests presented great potential to adopt modified carbide slag in fluidized bed calcium looping gasification. After 8 cycles of gasification/regeneration, H 2 concentration and H 2 yield with CS15 were stabilized at 49.8% and 32.7 mg/g biomass , which were increased by 11.5% and 17.7% in comparison to those with CS.

Promoted calcium looping H2 production via catalytic reforming of polycyclic aromatic hydrocarbon using a synthesized CO2 absorbent prepared by impregnation

Developing a Novel CaO-Based Sorbent for Promoted CO2 Capture and Tar Reduction

A Novel Hybrid Iron-Calcium Catalyst/absorbent for Enhanced Hydrogen Production Via Catalytic Tar Reforming with In-Situ CO2 Capture

Ca based high temperature CO2 absorbents for sorption enhanced reforming process

Enhanced hydrogen production via catalytic toluene reforming with in situ carbon dioxide capture: Effects of a hybrid iron-calcium composite prepared by impregnation

Chemical Looping Reforming of Coal Tar Vapor on the Surface of CaO-Modified Fe-Based Oxygen Carrier

Biomass calcium looping gasification via cement-modified carbide slag in fluidized bed: an examination on enhanced multi-cycle CO2 capture and hydrogen production

Improved performance of modified CaO-Al2O3 based pellets for CO2 capture under realistic Ca-looping conditions

Strengthening performance of Al-stabilized, CaO-based CO 2 sorbent pellets by the combination of impregnated layer solution combustion and graphite-moulding

Development and performance of CaO/La2O3 sorbents during calcium looping cycles for CO2 capture

Hydrophobic interface-assisted casting of Al-supported, CaO-based sorbent pellets for high-temperature CO 2 capture

Pt-Calcium-Cobaltate Enables Sorption-Enhanced Steam Reforming of Glycerol Coupled with Chemical Looping CH4 Combustion

Simultaneous in-situ tar abatement and H2-enriched syngas production via heterogeneous doping of LaFeO3 during chemical looping gasification of microalgae

Development of a Steel-Slag-Based, Iron-Functionalized Sorbent for an Autothermal Carbon Dioxide Capture Process.

Effect of Doped Lanthanum and Aluminum Salts on Calcium Looping Cycle for CO2 Capture

Ca-enhanced hematite oxygen carriers for chemical looping reforming of biomass pyrolyzed gas coupled with CO2 splitting

Chemical Looping Combustion-Adsorption Of Hcl-Containing Syngas Using Alkaline-Earth Coated Iron Ore Composites For Simultaneous Purification And Combustion Enhancement

Experimental Investigation of Fe–Ni–Al Oxygen Carrier Derived from Hydrotalcite-like Precursors for the Chemical Looping Gasification of Biomass Char

Catalytic calcium-looping gasification of biochar with in situ CO2 utilization with improved energy efficiency

Pt–calcium cobaltate enables sorption‐enhanced steam reforming of glycerol coupled with chemical‐looping CH 4 combustion