Abstract:The highly reactive chemical nature of aluminum makes it production energy-intensive or essentially impossible to extract alloying elements from Al-based liquids. Using molten salt fluxing and electrolysis processes can effectively refine coarse Al scraps. However, the generation of toxic gases and hazardous dross during these processes can cause significant environmental protection challenges and result in notable social concerns. Therefore, the primary recycling of post-consumer Al in industries currently proceeds mainly in a cascade manner, which is not sustainable when considering the Al cycle trends in the coming decades. Herein, we develop a novel process to separate primary Al from the crystallizing liquid when a constant electromagnetic force (EMF) is applied. Using this technique, we successfully upgraded Al–7mass%Si (hereafter, unless specified otherwise) alloy to approximately Al–3.6%Si in directional solidification. The separation mechanism was discussed in terms of the electrical properties of the respective phases during solidification. Fluid flow simulation results were applied to elucidate the separation behavior in the alloy. The upper and lower limits to separate the crystallizing alloy into an Al-rich and Si-rich areas were determined when the controlling factors were clarified, which made it possible to scale up the present laboratory-based setup to an industrial level. Moreover, the energy consumption of the process was slightly higher than that required for remelting only. Using the EMF technique to separate the crystallizing alloy into Al-rich and Si-rich regions did not produce hazardous dross or toxic gases. This energy-saving and eco-friendly process can provide a breakthrough to overcome the "dead metal" crisis and thus realize sustainability by upgrading recycling of post-consumer hypoeutectic Al–Si casting alloys.

Upcycled high-strength aluminum alloys from scrap through solid-phase alloying

Ductile and Corrosion-Resistant Aluminum Alloy From Recycled Secondary Aluminum Scraps Containing Iron Impurities

Making sustainable aluminum by recycling scrap: The science of “dirty” alloys

Recycling aluminum alloys for the automotive industry: Breaking the source-sink paradigm

Effect of Continuous Casting and Heat Treatment Parameters on the Microstructure and Mechanical Properties of Recycled EN AW-2007 Alloy

Effect of Recycling on the Mechanical Properties of 6000 Series Aluminum-Alloy Sheet

Improved iron-tolerance in recycled aluminum alloys via direct strip casting process

Upgrading recycling of Al–7 wt%Si alloys using electromagnetic force in directional solidification

A New Recycled Al–Si–Mg Alloy for Sustainable Structural Die Casting Applications

Microstructure evolution of recycled 7075 aluminum alloy and its mechanical and corrosion properties

A solid-state electrolysis process for upcycling aluminium scrap

Reprocessing of AW2007, AW6082 and AW7075 aluminium chips by using sintering and forging operations

Future of the fringe: scenarios for Melbourne's peri-urban growth

A new process for efficient purification of 6061 aluminum alloy scrap under semi-solid and super-gravity conditions

Synchronously enhancing the strength, toughness, and stress corrosion resistance of high-end aluminum alloys via interpretable machine learning

Effect of Various Forms of Aluminum 6082 on the Mechanical Properties, Microstructure and Surface Modification of the Profile after Extrusion Process

Antiretroviral combination may put pregnant women at risk of fatal lactic acidosis.

Using multicomponent recycled electronic waste alloys to produce high entropy alloys

Evolutionary mechanism of the precipitation behavior and organization of iron-containing intermetallic phase during solidification of recycled high-Fe Al-Zn-Mg-Cu melts

Microstructure evolution and properties comparation of industrial grade-maintained 7050-T7451 plate recycled from machining chips

Recycled aluminium feedstock in metal additive manufacturing: A state of the art review