Electrically Tunable Diode-Based Nonlinear Transmission Line

Nicholas Gardner,Kalyan Durbhakula,Anthony Caruso

DOI: https://doi.org/10.1109/tmtt.2024.3359535

IF: 4.3

2024-01-01

IEEE Transactions on Microwave Theory and Techniques

Abstract:Diode-based nonlinear transmission lines (D-NLTLs) are capable of generating pulsed radio frequency (RF) signals with center frequency ( $f_{{c}}$ ) in the ones-of-GHz range and volumetric power densities ( $\rho_{{v}}$ ) on the single GW/cm $^{{3}}$ . However, the use of monopolar excitation signals limits the $f_{{c}}$ range and incurs impedance losses that reduce $\rho_{{v}}$ . To mitigate this issue, a direct current (dc) bias was used to create an effective bipolar input, reducing impedance losses, resulting in a 37% increase in $f_{{c}}$ and a 4 $\times$ improvement in $\rho_{{v}}$ compared to the unbiased case. Observed increases in $f_{{c}}$ and $\rho_{{v}}$ are attributed to a 2.67 $\times$ increase in voltage amplitude measured after the connection between the pulsed source and D-NLTL over that of a monopolar pulse, which is attributed to increased diode saturation. Additionally, the effects of a dc bias on network impedance are demonstrated through electrical tuning of $f_{{c}}$ over a range of 160–260 MHz with monopolar excitation signals. Overall, results indicate a dc bias can enable $f_{{c}}$ modulation, increase $f_{{c}}$ and $\rho_{{v}}$ range and ceiling, and reduce impedance losses in a D-NLTL network.

engineering, electrical & electronic