Abstract:Abstract Per recent analyses, in the near future, over half amount of the oil extracted globally, will require some form of enhanced oil recovery (EOR) techniques. Existing literature and historical investigations suggest that in oil reservoirs having viscosities between 10 – 150 m.Pa.s, there is a significant potential for tertiary recovery through the application of polymer flooding. For reservoir oil viscosities above 150 mPa.s, the polymer pumping efficiency goes down as polymer injectivity reduces significantly with increasing injection water viscosity that are used to attain a favorable mobility ratio at such high oil viscosities. To overcome this limiting factor, in this study, we propose the use of supramolecular assemblies (SMA) that have adjustable viscosity properties. Complexation of long-chain amino-amides and maleic acid is used to make these assemblies, which allow it to have reversible viscosity depending on the solution pH level. To maintain high injection efficiency, during pumping, SMA solutions will be kept at low viscosity values. On entry in deep reservoir or at oil contact phase, through introduction of an external stimulus the viscosity of SMA solution will be reversed to a much higher viscosity. This will allow to sufficiently improve the mobility ratio. Preliminary results from lab-scale studies have indicated that along with reversibly adjustable viscosity property, SMA solutions are also tolerant to high temperatures and salt concentrations. Supramolecular solutions can be considered as healable polymer systems, since unlike conventional polymer they disassemble and re-assemble when exposed to high temperature and stress conditions. In such conditions, conventional polymers generally undergo degradation. Additionally, through molecular scission processes SMA solutions can also be used in highly confining environments as well as in permafrost conditions and thin zones where conventional thermal techniques are not applicable. The objective of this work is the development of novel SMA system that have the aforementioned properties of reversibly adjustable viscosity through pH, tolerance to high temperature and salt concentrations through desired interfacial properties. Lab-scale preliminary results have shown the potential economic benefits of the use of SMA solutions on a field-wide scale. Based on the results, it must be emphasized that SMA systems have a worldwide application in oil reservoirs for EOR purposes.

Synthesis of a novel flocculant with dimethylamino propylmethacrylamide and polyether and its flocculation performance

Preparation of a selective flocculant for treatment of oily wastewater produced from polymer flooding and its flocculant mechanism

Smart Nanoparticles for Conformance Improvement in Waterflooding

A novel interface-active cationic flocculant for the oil-water separation of oily wastewater produced from polymer flooding

Ultrasound-initiated synthesis of cationic polyacrylamide for oily wastewater treatment: Enhanced interaction between the flocculant and contaminants

Preparation of acrylate-modified cationic flocculant by polymer reaction and its performance in treating oilfield-produced water

Efficient demulsification of cationic polyacrylate for oil-in-water emulsion: Synergistic effect of adsorption bridging and interfacial film breaking

Synthesis of hydrophobically modified flocculant by aqueous dispersion polymerization and its application in oily wastewater treatment

Removal of emulsified oil from water using hydrophobic modified cationic polyacrylamide flocculants synthesized from low-pressure UV initiation

The effect of polymer on the floatation-flocculation performance of flocculant for treating polymer flooding produced water

A New Macromolecular Flocculant in the Treatment of Oily Wastewater in Oilfields

Synthesis and characterization of hydrophobically associating cationic polyacrylamide

Synthesis of cationic polyacrylamide via inverse emulsion polymerization method for the application in water treatment

Characterization and Dimethyl Phthalate Flocculation Performance of the Cationic Polyacrylamide Flocculant P(AM-DMDAAC) Produced by Microwave-Assisted Synthesis

Effects of a New Synthetic Fe-PAM Flocculants on Filtration and Consolidation of Bentonite Slurry

Comparison of the effects of two flocculants on the interaction between dispersed phases in produced water during air floatation-flocculation

Synthesis and properties of AM/AMPS/MMA and cationic monomer copolymer flooding agent

Optimization of and Mechanism for the Coagulation–flocculation of Oil-Field Wastewater from Polymer Flooding

Hydrophobic modification of cationic microblocked polyacrylamide and its enhanced flocculation performance for oily wastewater treatment

UV-initiated polymerization of hydrophobically associating cationic flocculants: Synthesis, characterization, and dewatering properties

Copolymerization behavior of diallyldimethylammonium chloride‐nonionic macromonomer in water‐ether mixture solution and flotation performance of the copolymer for treating oily wastewater