Abstract:The European Union imposed minimum industrial fan efficiency levels in 2013 and then increased them in 2015. In the USA, the Department of Energy (DoE) is also developing regulations aimed at eliminating inefficient industrial fans from the market by 2023. A consequence of this regulatory activity is a need to apply design methods originally developed within the aerospace community to the design of high efficiency industrial fans. In this paper, we present a process used to design, numerically verify and experimentally test a high-pressure single-stage axial fan. The goal was a fan design capable of working over a range of blade angles in combination with a single fixed cambered plate stator. We present the process used when selecting blade airfoil sections and the vortex distribution along the blade span. The selected methodology is based on a coupling between the aerodynamic response of each blade profile and the chosen vortex distribution, creating a direct link between the load distribution and the aerodynamic capability of the blade profile section. This link is used to develop radial distributions of blade twist and chord for the selected blade profiles that result in the required radial work distribution. The design method has been enhanced through intermediate verifications using two different numerical methodologies. The methodologies are based on different approaches, in so doing providing confidence in the verification process. The final blade design has been analyzed using a three-dimensional computational fluid dynamic (CFD) code. Results of the CFD analysis indicate that performance of the final blade design is consistent with the design specifications. The paper concludes with a comparison between predicted and experimentally measured performance. The need is clarified for balance between computational and empirical approaches. When used together the development effort results in a lower cost and higher efficiency design than would have been possible using either approach in isolation.

On the Performance of Variable-Geometry Ducted E-Fans

Reverse Thrust Aerodynamics of Variable Pitch Fans

Ducted fans for hybrid electric propulsion of small aircraft

Effect of Gurney Flap on Performance and Aeroacoustics of Variable-Pitch Axial Fans

Sizing Considerations of an Electric Ducted Fan for Hybrid Energy Aircraft

The Overall Design of Variable Diameter Ducted Fan in the Aircraft

Flow physics and loss mechanisms of tip leakage flow in variable-blade-pitch-angle ducted fans

Multi-fidelity Optimization of Ducted Fan for Evtol Aircraft

Simulation of Optimization of Variable Geometry for a Turbofan Engine of a Missile

Numerical investigation of the aerodynamic performance and loss mechanism in a low bypass ratio variable cycle engine fan

Numerical Study on Dynamic Performance of a Ducted Fan Moving in Proximity to Ground and Ceiling

Analysis of the Flow Capacity of Variable Cycle Split Fans at the Middle Speed

Influence of diversified dihedral stator on the thermodynamic performance and flow loss characteristics of a variable core driven fan stage

Design of a Single Stage Variable Pitch Axial Fan

Study of geometric parameters for the design of short intakes with fan modelling

The matching characteristics and flow mechanisms of partial-height booster rotor and fan rotor for a high-throughflow fan

Modeling of Ducted-Fan and Motor in an Electric Aircraft and a Preliminary Integrated Design

CFD Study of an Annular-Ducted Fan Lift System for VTOL Aircraft

Unified Assessment of Open and Ducted Propulsors

Active Subspace-Based Performance Analysis of Supersonic Through-Flow Fan Rotor